User manual ENVISION H191W

[. . . ] Do not spray liquid directly - it is best to lightly spray on to a cloth and wipe. If liquid gets inside the monitor it can cause electrical shock and/or damage to the unit. If you encounter a problem, please check the "Troubleshooting" section first. If this does not resolve the problem do not attempt to repair the monitor by yourself; opening or removing covers can lead to injury or death through electrocution among other hazards. [. . . ] 4) should light up blue. 2. Adjust the image to meet your requirements (see the following sections "Basic Setup" and "Image settings using the OSD menu"). 3. If there is no image displayed on the monitor, consult the section "Troubleshooting". BASIC SETUP Automatic Image Adjustment You can adjust the image settings (such as brightness, contrast, image position, phase, etc. ) manually or by using the LCD monitor's automatic image adjustment feature. This will adjust the image parameters to their optimal settings for the current graphics mode. The process will take a short while until completed. Shortcut for adjusting brightness and contrast You can adjust contrast and brightness directly by pressing the SEL/MENU button ( in fig. then you need to press SEL/MENU to select either brightness or contrast then press menu to activate it, Press the in fig. 4) to increase the contrast/brightness or the /INPUT button ( button ( in fig. 4) to decrease it. 4 IMAGE SETTINGS USING THE OSD MENU English The OSD menu is a window on your screen that allows you to view and change display settings. To change an OSD setting: Deutsch Français Figure 4. Monitor features Italiano Press the SEL/MENU button ( in fig. 4) to display the OSD menu on the screen. There are a total of 6 OSD submenus divided by categories. Select the desired submenu by pressing the OSD button SEL/MENU button ( in fig. 4); see section "OSD Menu Functions"). 4) to activate the selected function or associated submenu. If you selected submenu, now select the sub-function you want using the OSD buttons(and in fig. Set the desired value using the OSD button or . Repeat setups 2-5 to make further adjustments as needed. The OSD menu automatically disappears if no changes are made for more than 45 seconds (default setting). You can close it manually by pressing the EXIT/AUTO (in fig. 4) button Nederlands 6. 5 OSD MENU FUNCTIONS Brightness/Contrast Controls the picture's contrast, brightness, black level and auto level. Image Control Auto Adjustment: Automatically selects the optimal settings for image parameters (image position, phase, etc. ) by using the button SEL/MENU ( in fig. Position: Controls the picture's horizontal position. [. . . ] Factory recall: SELECT: Start EXIT: Back Information The optimum resolution for this monitor is 1440 × 900 @ 60KHz . 8 TROUBLESHOOTING English Blank Screen Power indicator is off Make sure the power cable and the power adapter are connected properly (see section "Connecting"). Make sure that the monitor was turned on using the power switch (see section "Startup"). Deutsch Power indicator lights orange A screen saver may have activated automatically after a certain period of inactivity. Press any key on your keyboard or move the mouse. "Check signal cable"message Is the signal cable connected to the monitor and the PC's graphics port (see section "Connecting")?Is the PC turned on (see your PC's documentation)? Français Display Problems Image is displaced to the left/right or to the top/bottom If the image appears normal but off-center, you can adjust it using the OSD functions. [. . . ]