User manual EPSON EB-696UI INSTALLATION GUIDE (1.0)

[. . . ] XX(XXX) Español Français English Using the Product Safely Safety Instructions For your safety, read all the instructions in this guide before using this product. Incorrect handling that ignores instructions in this guide could damage this product or could result in personal injury or property damage. Keep this installation guide at hand for future reference. Read the User's Guide and Safety Instructions for your projector and follow the instructions in these documents. [. . . ] The infrared deflector will not function correctly. Arc Correction When fine-tuning the shape of the projected image, perform Arc Correction. A Turn on the projector, and then press the [Menu] button Using the Remote Control Using the Control Panel b Select Geometry Correction from Settings 48 Installation Guide c Select Arc Correction d Select Arc Correction e Select the side you want to correct f Correct the selected side If the message "Cannot adjust any further. "is displayed while adjusting, you cannot adjust the shape any further in the direction indicated by the gray triangle. G Repeat steps 5 and 6 as needed to adjust any remaining sides Calibrating the pen Check that adjusting the position of the projector is complete before you start calibrating the interactive pen. S "Adjusting the Position of the Projector" p. 41 49 Installation Guide There are two methods available for calibrating the pen; Auto Calibration and Manual Calibration. When calibrating the pen for the first time after installing the projector, perform Manual Calibration for optimum calibration. For the Auto Calibration method, see the projector's User's Guide (on the Document CD-ROM). C When two projectors are installed in parallel and you are using the interactive function, set the multiprojection interactive features before adjusting the pen. S "When two projectors are installed in parallel and you are using the interactive function" p. 92 a Turn on the projector, and then press the [Menu] button Using the Remote Control Using the Control Panel b Select Easy Interactive Function from Extended c Select Manual Calibration 50 Installation Guide d Check that the screen is in focus, and then select Yes A green dot is displayed at the top left of the projection screen. E Touch the center of the dot with the pen tip of the interactive pen The dot disappears and moves to the next position. C Make sure you touch the center of the dot. Otherwise, it may not be positioned correctly. 51 Installation Guide f Repeat step 5 until all of the dots disappear The dot appears at the top left first and then moves towards the bottom right. When all of the dots disappear, calibration is complete. C • Check that there are no obstacles between the interactive pen and the Interactive pen receiver ( ). € If you touch the wrong position, press the [Esc] button on the remote control to return to the previous dot. € To cancel calibration, hold down the [Esc] button for two seconds. 52 Installation Guide Attaching the Covers a Attach the wall plate covers Install the right cover first. C • Depending on the cable configurations, you may need to cut notches ( ) in the wall plate covers to route the cables. [. . . ] The projector turns off and only the power indicator is lit blue. 105 Appendix Copying saved settings to other projectors a b c Disconnect the power cord from the projector, and check that all of the projector's indicators have turned off Connect the computer's USB port to the projector's USB-B port with a USB cable While holding down the [Menu] button on the remote control or the control panel, connect the power cord to the projector The status indicator and the power indicator turn blue, and the lamp indicator and the temperature indicator turn orange. When all of the projector's indicators turn on, release the [Menu] button. The projector is recognized as a removable disk by the computer. [. . . ]