User manual EPSON EB-824

[. . . ] . Snap off, remove, and then install. Match the ink color with the tank, and then fill with all of the ink. Install. Do not open the initial setup ink bottle package or the refill ink bottle package until you are ready to fill the ink tank. The ink bottle is vacuum packed to maintain its reliability. For initial setup Repeat steps to for each ink bottle. Close. 2 Filling Ink Before printing, be sure to hook the ink tank unit onto the product. [. . . ] Do not lay the ink tank unit down, or position the unit higher or lower than the product. The illustrations in this guide may differ from your actual product. Do not pull the tubes. Hook onto. Unhook. Loading Paper and Copying Connect and plug in. Turn on. Press for 3 seconds until starts flashing. Charging ink is started. Charging ink takes about 20 minutes. Wait until the light turns on. 3 Connecting to the Computer Do not connect the USB cable until you are instructed to do so. Loading Capacity (sheets) for copying   Do not load paper above mark inside the edge guide.   Load paper with its printable side face up. If the Firewall alert appears, allow access for Epson applications. Plain Paper Bright White Ink Jet Paper 11 mm 80 A4 Windows Windows Mac Mac A B Transporting Insert. Check and proceed. Secure print head. Set transportation lock. Install securely. Make sure to hook on. Without ink bottles, set in original or similar box. A Windows Select and follow the instructions. B Mac Select and follow the instructions. Keep the product level as you transport it. Be sure to keep the ink bottle upright when tightening the cap, and take measures to prevent ink from leaking as you transport it. After you move it, remove the tape securing the print head and the covers of ink tanks, then set the transportation lock to the unlocked position. If you notice a decline in print quality, run a cleaning cycle or align the print head. Store the covers at the side of the product. Windows 7/Vista: AutoPlay window. Only the software with a selected check box is installed. Doing so may cause fire. Except as specifically explained in your documentation, do not attempt to service the product yourself. It is time to reset the ink levels. Ink level may have reached the lower line. See the “Refilling Ink” section to fill all ink tanks with ink to clear the error. Fatal error. If this does not clear the error, turn the product off and check inside the product for jammed paper or foreign objects. For instructions on how to remove jammed paper, see the troubleshooting section of the online User’s Guide. Keep ink bottles and the ink tank unit out of the reach of children and do not drink the ink. Do not tilt or shake an ink bottle after removing its seal; this can cause leakage. Be sure to keep the ink bottles upright and do not subject them to impacts or temperature changes. The product’s ink pads are nearing or at the end of their service life. Contact Epson Support to replace ink pads. When the product’s ink pads are nearing the end of their service life, you can resume printing by pressing   or   . The paper light and the ink light flash alternately. If ink gets on your skin, wash the area thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. If discomfort or vision problems continue after a thorough flushing, see a doctor immediately. [. . . ] If ink gets into your eyes, flush them immediately with water. If discomfort or vision problems continue after a thorough flushing, see a doctor immediately. If ink gets into your mouth, spit it out immediately and see a doctor right away. An error occurred while establishing the Wi-Fi connection. Press Network Guide. to clear the error and try again. [. . . ]