User manual EPSON EB-W16SK STARTUP GUIDE

[. . . ] Startup Guide This guide explains how to stack two projectors one on top of the other, and then project as one image. Please read this guide before getting started. By using this stacked projection, you can realize a brighter, clearer image. This also allows large screen projection of 3D images that can be viewed by a large audience. [. . . ] Connect the commander's USB(TypeA) port to the receiver's USB(TypeB) port with a USB cable. The projectors will not be linked if the wrong USB ports are connected with the USB cable. Commander USB TypeA Receiver Commander USB TypeB Power cable (supplied) USB cable (supplied) Power inlet Receiver Power cable (supplied) Power inlet 10 • First, check that the commander and the receiver are connected with a USB cable. Connecting to a computer Connecting with computer cables • Computer cables (available in local stores x3) • Audio cable (available in local stores) *When outputting audio • Splitter (available in local stores) A B Connect the splitter to the computer with a computer cable. C Connect the commander or receiver to the computer with an audio cable. audio is output from the connected projector. Connect the commander and the receiver to the splitter with computer cables. Commander in L - out - R (commercially available) Computer cable Computer1 Receiver (commercially available) Computer cable (commercially available) Splitter (commercially available) Computer cable Computer1 Commander (commercially available) Audio cable Audio-L/R Receiver Audio-L/R 11 English • First, check that the commander and the receiver are connected with a USB cable. Connecting to a computer Connecting with HDMI cables • HDMI cables (available in local stores x3) • HDMI splitter (available in local stores) A Connect the splitter to the computer with an HDMI cable. B Connect the commander and the receiver to the splitter with HDMI cables. You can send the computer's audio with the projected image. When viewing 3D images, make sure you use HDMI cables and an HDMI splitter that support 3D signals. Commander HDMI in L - out - R (commercially available) HDMI cable Receiver (commercially available) HDMI cable (commercially available) HDMI splitter (commercially available) HDMI cable HDMI 12 • First, check that the commander and the receiver are connected with a USB cable. Connecting to video equipment Connecting with HDMI cables • HDMI cables (available in local stores x3) • HDMI splitter (available in local stores) A Connect the splitter to the video equipment with an HDMI cable. B Connect the commander and the receiver to the splitter with HDMI cables. English You can send the computer's audio with the projected image. When viewing 3D images, make sure you use HDMI cables and an HDMI splitter that support 3D signals. Commander HDMI in L - out - R (commercially available) HDMI cable Receiver (commercially available) HDMI cable (commercially available) HDMI splitter (commercially available) HDMI cable HDMI 13 Projecting Images Superimposing the images from the commander and the receiver Superimpose two images. When suspending the projectors from a ceiling, change the Projection mode before superimposing the images. You can change the Projection mode by holding down the [A/V Mute] button on the remote control for about five seconds. [. . . ] Select the projector you want to adjust, and then press the [ ] button. Correcting using H/V-Keystone Correct keystone distortion for the receiver's frame (green). Correcting using Quick Corner Correct the four corners of the receiver's frame (green) individually. Use the [ ] [ ] buttons to select the direction you want to correct, and then press the [ ] [ ] buttons to make corrections. [. . . ]