User manual EPSON ECOTANK ET-2500 STARTUP GUIDE

[. . . ] I C J Snap off, remove, and then close tightly. Windows (No CD/DVD drive) Mac OSX iOS/Android No PC Proceed to the next step (Section 3). 3 A D Turn on the printer and wait until P stops flashing. [. . . ] (b) A Remove all of the paper inside, including any torn pieces. A (a) cc Print a nozzle check pattern to check if the print head nozzles are clogged. Turn off the printer, and then turn it back on while holding down y. If you notice any missing segments or broken lines as shown in (b), go to step B. Do not touch the white flat cable, translucent part, and ink tubes inside the printer. If the ink level is below the lower line, go to step B to refill the tanks. See the “Clearing Paper Jam” section to remove paper and resume printing. No paper is loaded, or multiple sheets were fed at the same time. Load paper in the rear paper feed correctly and press x r or r x. Follow steps B to L in section 3 of the front page to complete initial ink charging. Cc Prolonged use of the printer when the ink level is below the lower line could damage the printer. Make sure you visually check the ink levels. Hold down y for 3 seconds until the power light starts flashing. The cleaning uses some ink from all tanks, so run the cleaning only if print quality declines on your prints. QQ Clearing Paper Jam Suppression d’un bourrage papier Papierstau beseitigen Papierstoring verhelpen If paper still remains near the rear paper feed, gently pull it out. Refer to steps B to H in section 3 of the front page to refill the tanks to the upper line. [. . . ] Do not place or store the product outdoors, near excessive dirt or dust, water, heat sources, or in locations subject to shocks, vibrations, high temperature or humidity. Take care not to spill liquid on the product and not to handle the product with wet hands. If ink gets on your skin, wash the area thoroughly with soap and water. [. . . ]