User manual EPSON ELPMB22 INSTALLATION MANUAL

[. . . ] Do not use a power cable that is damaged or modified. Do not pull the power cable with too much force when routing the cable through the arm unit. Do not put any thing heavier than the projector on the arm unit. Doing so could cause the arm unit to fall and cause personal injury or property damage. [. . . ] It could cause personal injury or property damage. If the screws are not properly tightened, it could cause the projector to fall and cause personal injury or property damage. Never loosen the bolts and nuts after installation. confirm that the screws have not become loosened on a regular basis. If you find any loose, tighten the screws firmly. If the screws are not properly tightened, it could cause the projector to fall and cause personal injury or property damage. Do not use in places where the humidity is high. Do not install at place where there is a lot of dust, or a place where it may come into contact with smoke or steam such as near cooking appliances or a humidifier. Do not change the angle of this mount or the projector with excess force. Too much force could damage the mount and could cause personal injury or property damage. This mount is for short throw projector EB-410W/PowerLite 410W. Make sure to follow the steps below to install the mount. If you ignore these steps, the mount could fall down and could cause personal injury or property damage. the combined mass of this mount and the projector is approximately 14 kg (31 lb) at maximum. Before starting the installation, carefully check the construction, material, and strength of the wall and use the most appropriate methods to install. Installing the wall plate to the wall Attach the wall plate to the wall using M8 × 50 mm anchor (more than 3 pcs. Set the horizontal center of the wall plate 8 cm (3. ) left from the horizontal center of the whiteboard. ) space between the top of the whiteboard and the bottom of the wall plate. If the 16:9 of maximum distance (tele) screen size is used, refer to the table in the previous page. Horizontal center of the wall plate If you insert at four points, use four point As or four point Bs as shown below. When you set the projector on the wall with this mount, the wall requires enough strength to hold the projector and this mount. [. . . ] If you project a 16:9 image at the minimum or maximum distance for your screen size, adjust the vertical slide (arm angle) using two screws (E) on the bottom of the arm plate. The arm goes up when tighten the screws and goes down when you loosen them. If the screws are not tightened firmly, it could cause the projector to fall and cause personal injury or property damage. Attach the wall plate cover, cable cover, and arm cover using the hexagon wrench (M4) and six M4 × 12 mm bolts. [. . . ]