User manual EPSON EMP-715 annexe 2

[. . . ] Before use Installation Connections Projection Useful Functions Adjustments and Setting Troubleshooting Maintenance Others Accessory Verification Check to confirm that the following items are included in the package when removing the projector and accessories from the box. Contact your dealer if any items are found to be missing. · Projector Lens Cover with string · Remote Control · Two alkaline dry cells for the remote control · Power Cord · Computer Cable (mini D-Sub 15pin/ mini D-Sub 15pin) · Video/ Audio Cable (Red/White/Yellow) · USB Mouse Cable · PS/2 Mouse Cable PS/2 MOUSE · Owner's Manual (this document) · EasyMP User's Guide · Safety Instructions/ World-Wide Warranty Terms · Memory Card Set (8Mbyte compact flash card + PC card adapter) · EasyMP Software (CD-ROM) · Dummy card (Dummy card and card case) * The memory set has been inserted into the projector. Types of Manual The documentation for your EPSON projector is divided into the following three manuals. The manuals cover the following topics. Safety Instructions/World-Wide Warranty Terms This manual contains information on using the projector safely, and also includes World-Wide Warranty Terms and a Troubleshooting check sheet. Be sure to read this manual thoroughly before using the projector. [. . . ] (see page 66) Press the [Enter] button and follow the instructions displayed on the confirmation screen. · The saving procedure requires a certain amount of time to complete. Do not attempt to operate the projector or the equipment connected to the projector while this procedure is running. Failure to observe this may result in damage. · The size that can be registered is 400 x 300 dots. · The display size will be adjusted when video images are being projected. Default Value Center value (0) P-in-P Composite No-Signal Msg Blue Prompt A/V Mute ON Black Sleep Mode ON Reset - Capture Image capture - User 's Logo Capture EPSON's logo 62 - Menu Operations Top Menu Advanced Sub Menu Language Function Sets the language with which messages are to be displayed. Press the [Enter] button and select the required language from the language selection menu displayed. Displays the user logo during warm-up after the power has been switched on. · The user logo must be registered and set up before it can be amended. Adjusts the color temperature (*) of the image. Color temperature: Sets the color temperature. Press the [Enter] button and make the setting on the color setup menu displayed. RGB: Sets the strength of the RGB colors (red, green and blue. ) · Press the [Enter] button, select the R (red), G (green) and B (blue) items on the color setup menu displayed, and then make the necessary setting. · Observe the status of the screen when adjusting the settings. Set at [ON] to project images onto a half-transparent screen from the rear. The projected image will be inverted up, down, left and right when this is set at [ON]. Returns all advanced setting menu adjustment values to the default values. Press the [Enter] button and then select [Yes] on the confirmation screen displayed. · Select [Reset All] to return all image and sound values to the default settings. (Displays the current settings) Default Value English Startup Screen ON Color Setting Color temperature Rear Proj. Ceiling Reset OFF OFF - About Reset all Execute - Returns all items in the set-up menus to the default values. Press the [Enter] button and then select [Yes] on the confirmation screen displayed. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. [. . . ]