User manual EPSON EMP-TS10

[. . . ] The documentation for your EPSON projector is divided into the following four manuals. refer to the manuals in the order given below. Unpacking and Installation Guide This manual contains information on the procedures from unpacking the projector through to starting to use the projector, and also describes the included accessories. Safety Instructions/ World-Wide Warranty Terms This manual contains information on using the projector safely, and also includes safety instructions, worldwide warranty terms and a troubleshooting check sheet. [. . . ] Once the cooling fan has stopped, unplug the power cord and then plug it back in again. Check that the air inlet and air outlet are clear, and that the projector is not positioned against a wall. If the air filter is dirty, it should be cleaned. When the power cord is plugged back in, the projector will return to its previous state, so press the [Power] button on either the remote control or the projector's control panel to turn it back on. If the projector continues to overheat even after the above points have been checked, or if the indicators show a problem when the power is turned back on, stop using the projector, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/ World-Wide Warranty Terms included in the package. (This is not an abnormality, but if the temperature rises too high again, projection will stop automatically. ) · Set the projector up in a place which is well-ventilated, and so that the air inlet and exhaust vents are clear. The lamp service life can become shorter than normal as a result of the usage conditions, and so the lamp should be replaced as soon as possible. The cool-down (lamp cooling operation) period lasts for about 2 minutes. The [Power] button will not operate during the cool-down period. When cool-down is complete, the indicator will stop flashing and light orange. If the projector is not operating properly even though the indicators are all showing normal, refer If an indicator is showing a status which does not appear in the previous tables, contact your If any of the following problems occur and the indicators do not offer a solution, refer to the pages given for each problem. 41 Images appear dark Images appear green No sound can be heard The power does not turn off p. 6) Check the power cord connection at the power inlet of the projector and at the wall outlet. You can then use the [Power] button on either the remote control or the projector's control panel. Was the power turned off and then straight back on again?While the indicator is flashing orange (during cooldown ), the [Power] button on either the remote control or the projector's control panel will not operate. Have you pressed the [Power] button on either the remote control or the projector's control panel?When sleep mode has been set to ON, the lamp turns off automatically if no operations are carried out for 30 minutes while no video signal is being input. The indicator lights orange at this time. Some input images, such as screen savers, may be completely black. 7) Refer to the documentation provided with your computer for details on changing the resolution and frequency of the image signals being output from the computer. [. . . ] The carrier signal which is contained in the color bar signal used in high-definition TV (HDTV) transmissions. According to 47CFR, Part 2 and 15 Class B Personal Computers and Peripherals; and/or CPU Boards and Power Supplies used with Class B Personal Computers Declare under sole responsibility that the product identified herein, complies with 47CFR Part 2 and 15 of the FCC rules as a Class B digital device. Each product marketed, is identical to the representative unit tested and found to be compliant with the standards. Records maintained continue to reflect the equipment being produced can be expected to be within the variation accepted, due to quantity production and testing on a statistical basis as required by 47CFR 2. [. . . ]