User manual EPSON EMP-X3

[. . . ] If you would like to make further minor adjustments to the effects of automatic keystone correction, use panel. on the projector's control Tip If the front adjustable feet have been extended, they can be retracted again by pressing and holding the foot adjust buttons on both sides of the projector and gently pushing down the front of the projector. A keystone correction reduces screen size. [. . . ] Press on the projector's control panel to adjust the keystone at this time. When the top is too wide When the bottom is too wide Adjustment / Turning Off the Projector Adjustment "Using the Configuration Menu Functions" in User's Guide Other adjustments Press the on the remote control to display the configuration menu on the screen. You can then adjust the individual brightness, contrast and sharpness settings. Press control. on the remote The configuration menu appears. Tip Press menu level. to return to the previous Use and to select the menu item to be set, and then press . The selected sub-menu then appears. Remote control Main menu Sub-menu (Video) Use and to select an item, and then use and to adjust the setting or select "ON" or "OFF". To change the setting for another item, repeat steps and . To close the menu, press . Turning Off the Projector "Turning Off the Projector" in User's Guide Turn off the power for the equipment connected to the projector. Press on the projector's control panel or the remote control twice to turn off the power. To prevent mis-operation, a confirmation message appears when or The power turns off when you press the button once more. You can also press on the is pressed once. or twice Tip If you press a button other than on the projector's control panel or on the remote control while the confirmation message is displayed, the message will disappear and the projector will return to its original condition. in quick succession to turn off the power. The Power indicator will flash orange (cool-down in progress/about 45 seconds). After the Power indicator lights orange steadily you can disconnect the power cable. If the power cable is disconnected while the Power indicator is still flashing orange, it may cause problems with projector operation. Power indicator Adjustment / Turning Off the Projector Functions for Enhancing Projection "Wireless Mouse Function" in User's Guide The following functions for enhancing the projection are explained here. Then select the type of screen to be displayed when projection is being stopped. The following choices are available. The default setting is the black screen. The EPSON logo is recorded as the default user's logo. Use the menus to set your own user's logo if desired. Solid black Solid blue User's logo Functions for Enhancing Projection Troubleshooting "Using the Help" in User's Guide Viewing the online help This projector is provided with an online help function which can be used when you have a problem using the projector. Press on the projector's control panel. Press on the Projector projector's control panel. Press on the projector's control panel. Or press on the remote control. The help contents will then be displayed. To clear the help display, press on the projector's control panel. "When Having Some Trouble" in User's Guide Checking the indicators You can check the status of the projector using the indicators on the projector's control panel. Refer to the table below for details on checking and remedying the cause of problems. Warning indicator Power indicator (Warning) indicator Status : lit : flashing Problem and remedy High temperature inside projector (overheating) The lamp will turn off automatically and projection will stop. [. . . ] Wait for about 5 minutes without operating the projector. After 5 minutes have elapsed, unplug the power cable and then plug it back in again. The projector will return to its previous condition. [. . . ]