User manual EPSON EPL-8000

[. . . ] For United States Users This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and; if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] This requires you to correct the problem and then press the CONTINUE button to clear the error. However, if the AUTO CONT option in SelecType is set to ON, some errors may clear automatically even though the problem remains. In this section, status messages are preceded by [S], warning messages are preceded by [W], and error messages are preceded by [E]. In some cases the message you see on your display also shows the printer mode. [E] ADD MEMORY FOR CH X The printer has insufficient memory available in the channel displayed. You may have changed the printer mode, increased the RX-BUFFER SIZE setting, or changed the CH INDIVIDUAL setting. To correct the error, decrease the RXBUFFER SIZE setting or change the CH INDIVIDUAL setting in SelecType. Changing the CH setting from INDIVIDUAL to AUTOSENSE may solve this problem. If necessary, add memory to your printer, 6-2 Troubleshooting Status and Error Messages CANCEL MANUAL FEED There is no paper in the manual-feed tray when you have selected manual feed. See Chapter 4 for instructions on loading paper in the manual-feed tray. To cancel manual feed, press the MANUAL button to feed paper from the cassette. This message alternates with the SET MANUAL message. [E] CARD MEMORY OVERFLOW This message indicates that the combined memory of the cards in slots A or B exceeds 4MB. Remove one or both of the cards and press the CONTINUE button. The printer is creating characters. [S] CHAR CREATING [S] COPY END X/X [E] COVER OPEN Multiple-copy printing is canceled (you pressed the COPY END button with the printer off line). Close the printer cover to continue printing. [S] DATA The printer has received data but is not yet printing, or is off line. To resume printing, press ON LINE if the printer is off line, or press FEED. Paper is not feeding into the printer from the specified cassette or has jammed on its way into the printer. If the paper is jammed at the paper cassette, open the printer case, remove the jammed paper from the standard paper cassette or optional paper cassette and then close the printer's covers. See the FEED JAM section in this chapter for more information. [E] FEED JAM [S] FONT CREATING The printer is creating a font. The printer is composing a graphic. [S] GRAPHIC DRAWING Troubleshooting 6-3 Status and Error Messages [E] ILLEGAL CARD The printer cannot read the card inserted in the slot indicated on the display. If the error message remains, make sure the printer is off line and remove the card. If the red CONTINUE light still flashes, press CONTINUE. / [S] INITIALLIZE The printer is being initialized to the factory settings. [E] [E] [E] INSERT IMAGING CRTG The imaging cartridge is not installed. Install it as described in Chapter 5. INSERT TRAY The standard paper cassette is not installed. The printer has insufficient memory available for the current task. [. . . ] Printer modes can emulate existing printers. proportional spacing Printing in which character width varies from character to character. For example, a capital W receives much more space than a lowercase i. The result looks more like a typeset book than a typewritten draft. The portion of the printer's memory used as an input buffer and for storing user-defined characters, downloaded fonts, and graphics images. [. . . ]