User manual EPSON EPL-N2000

[. . . ] ® Printing with the EPL-N2000 for the Network Administrator For Printing on the Multiprotocol Network: Y Y Y Y Y Y Y DOS Using Novell® NetWare® 2. x, 3. 1x, and 4. x Print Server or Remote Printer Windows® 3. 1 Using Novell® NetWare® 2. x, 3. 1x, and 4. x Print Server or Remote Printer Windows® 95 Using MS IPX or MS TCP/IP Windows® NT Using DLC, MS IPX, or TCP/IP Macintosh® Using EtherTalk® UNIX® Using lpd and ftp Commands IBM® OS/2 LAN® Server Using NetBEUI and TCP/IP User's Guide 4006480 C01-00 All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. No patent liability is assumed with respect to the use of the information contained herein. Neither is any liability assumed for damages resulting from the use of the information contained herein. [. . . ] Press Esc; then press Enter to save changes. Select Queues Serviced by Printer from the Print Server Configuration menu and assign a queue to the print server port from the Available Queues list. Press Esc to exit. Configuring the Ethernet card as a remote printer After setting up the NetWare print server, follow these steps to configure the Ethernet card in Remote Printer mode: 1. Click NetWare in the Summary dialog box. Highlight the printer you want to configure from the list. Note: If you have connected more than one printer with the same type of Ethernet card to the network, you can distinguish which card is which using the card's unique serial numbers. Press the status sheet button on the Ethernet card plate to print a status sheet for each printer and check the serial numbers. Click Open. Using Windows 3-15 5. Make sure that the correct serial number for the target Ethernet card is shown. Note: Press the status button on the Ethernet card plate to confirm the serial number for the printer in question. If a different serial number is shown on the status sheet, click Cancel to return to the Summary dialog box and select the correct one. Type the name of the print server you want to attach the printer to in the Print Server name box. It must be the same that you use in NetWare. Type the port number in the Port number box. It must be the same port number you use in the NetWare print server and print queue. Click OK to return to the Summary dialog box. Or, click Update to send the new settings to the Ethernet card without closing the Config dialog box. c Caution: Once you make changes to the Ethernet card, you must wait for at least five minutes before turning off or rebooting your printer. 10. After configuring the Ethernet card in Remote Printer mode, make sure that the remote printer can work correctly. For more information, see your NetWare documentation. 3-16 Using Windows Configuring the Ethernet Card for TCP/IP To use the printer on a TCP/IP network, you need to configure the Ethernet card for TCP/IP. Before using the Ethernet card with TCP/IP, you need to install the standard TCP/IP software in Windows NT. Note: In most cases, Windows 3. 1 can't use TCP/IP to share network printers. Installing LPR software in Windows NT Follow the steps below to install LPR software in Windows NT. If you have already installed the TCP/IP Network Print Service from TCP/IP Protocol and Related Components, you can skip these steps. [. . . ] From the Printer menu, choose Properties. Verify that the correct printer name and driver are selected. Click anywhere in the Print to dialog box and then choose Other at the bottom of the list. In the Available Print Monitors list, select EPSON Printer Network; then click OK. [. . . ]