User manual EPSON EPSONNET 802.11B

[. . . ] User's Guide Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON product. EPSON is not responsible for any use of this information as applied to other products. [. . . ] When you see the Wireless Server Search window, click START. Wait until you see server information like the following (you should not have to wait more than 60 seconds): This information appears when the server is found This number indicates the signal strength If WP-Admin fails to pick up a signal from the print server, try holding down the print server's test button for five seconds to reset it. The lights go out, then both the green and yellow lights come on briefly. The yellow light remains on when your network has a connection to the print server. If it still fails to pick up a signal, check the solutions beginning on page 40. 2. If WP-Admin picks up a signal from more than one print server, select the connection that matches the MAC address on the back of your print server. Check the signal strength to make sure you have a good link to the print server. You see a password window. 34 If you see the message Wireless Communication Failed, click OK, then click CONFIGURE again. If you continue to see this message, move the print server closer to your computer and access point, if you have one. Also, move it away from large metal objects and devices such as cordless phones or microwave ovens. 4. (The default password is null, or blank. ) The print server automatically detects the settings for your wireless network, and you see the Wireless Server Configuration screen: Must be the name of your Airport network For descriptions of all the settings on the Wireless Server Configuration screen, see Appendix A. 5. If you want, change the Server Name to something that is easy to remember, or enter a password to limit access to the Wireless Server Configuration screen. 35 This password does not affect access to your AirPort network. To enable password protection on your network, see page 44. 6. Make any other changes you want and click OK. You see the Wireless Server Search window again: Click QUIT 7. Click your printer icon, then click the EPSON printer port icon. Turn on background printing if you want, and close the Chooser. Now you're ready for wireless printing. For instructions, see the Printer Basics book that came with your printer. Once you've installed WP-Admin, you can change the print server's configuration at any time. Double-click the WP-Admin alias on your desktop, if you've created one, or double-click the EpsonNet folder on your hard drive and then double-click the WP-Admin icon. 36 Setting Up Additional Macintosh Computers Once the print server is configured on your wireless network, you can install the driver and select the printer on each Macintosh. Then make sure all your computers are set up for your wireless network. Make sure you have installed the printer driver and utility software. [. . . ] IF THESE LAWS APPLY, THEN ALL EXPRESS AND IMPLIED WARRANTIES ARE LIMITED TO THE WARRANTY PERIOD IDENTIFIED ABOVE. UNLESS STATED HEREIN, ANY STATEMENT OR REPRESENTATIONS MADE BY ANY OTHER PERSON OR FIRM ARE VOID. EXCEPT AS PROVIDED IN THIS WRITTEN WARRANTY, NEITHER EPSON AMERICA, INC. NOR ITS AFFILIATES SHALL BE LIABLE FOR ANY LOSS, INCONVENIENCE, OR DAMAGE, INCLUDING DIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES, RESULTING FROM THE USE OR INABILITY TO USE THE EPSON PRODUCT, WHETHER RESULTING FROM BREACH OF WARRANTY OR ANY OTHER LEGAL THEORY. [. . . ]