User manual EPSON ES-600C

[. . . ] EPSON ® User's Guide 4001572 CO1-00 FCC COMPLIANCE STATEMENT FOR AMERICAN USERS This equipment has been tested and found to comply With the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Problems fall in the following major categories: 0 D 0 0 Incorrect setup of the interface Inappropriate selection of the scanner functions Incorrect setup of your computer or software Incorrect operation of your software. Also see the documentation that came with your software, computer, and printer for possible solutions. Note: if you need to reset your scanner, use the RESETbutton under the DIP-switch cover. The READY light does not come on. Make sure the scanner is correctly connected to the computer and that the computer is turned on. Make sure the power cable is correctly plugged into the scanner and the power outlet. 4-2 Troubleshooting and Maintenance The scanner does not start scanning. See that the scanner's READY light is on. Make sure that you have selected the correct interface port and settings with your software. Also make sure the interface board on your computer is properly installed. If you are connecting the scanner with the SCSI interface, see that the terminator and SCSI ID are correctly set up. If you have other expansion boards in your computer, see that they are not interfering with the interrupt setting of the interface board for your scanner. (See your computer manual. ) The scanner software does not work properly. Be sure you have correctly installed your software. Check that the system requirements, such as the operating system version, are correct for using your software. See if the computer has enough memory for your software. If you are running other software at the same time, using RAM resident programs, or have many device drivers, the computer may not have enough memory remaining. (See your software and computer manuals. ) See whether your software supports the ES-600C. If it does, make sure that you correctly installed or set up the software. (See your software manuals. ) If your software does not support the ES-600C, select the Epson ES-300C. If the software still does not work properly, turn on the ES-300C emulation by turning DIP Switch l-8 on. If your software supports the ES-300C, your scanner can use the ES-300C emulation although a few of its functions may not be available. Troubleshooting and Maintenance 4-3 The entire image is distorted or blurred. Make sure that the document is placed flat against the document table (the glass area). You may have accidentally moved the document during scanning. Check the position of the document and do not move it while the scanner is operating. [. . . ] On the other hand, printers use subtractive primary colors-magenta, cyan and yellow (and often additional black to give more definition), and colors can differ slightly depending on the printing methods or the types of ink used. cl This setting compensates colors for the characteristics of color CRT displays. CRT displays cl Impact dot-matrix printers This setting compensates colors for the characteristics of impact dot-matrix color printers. This setting compensates colors for the characteristics of thermal transfer color printers. Ll Thermal transfer printers cl Ink jet printers This setting compensates colors for the characteristics of ink jet color printers. Appendix A-15 Glossary additive primary colors Primary colors which produce white when mixed in a certain proportion. These are red, green, and blue-the colors of the scanner lamps. bi-level data Image data which is composed of 1 bit/pixel. [. . . ]