User manual EPSON FX-85 ESCP MANUAL

[. . . ] Tear Off/Bin light 2 Reset When you press both the Font and Pitch buttons simultaneously, the printer clears buffer and returns to its default settings. 3 Pitch button Selects one of the pitch settings. Pitch lights Indicate which pitch is selected. Flashes when continuous paper is in the tear-off position. On when bin 1 of the optional cut-sheet feeder is selected. [. . . ] Note: Make sure the printer is off before you insert the paper in the paper slot. If you insert the paper while it is on, a paper jam may occur. Insert the paper into the front or bottom paper slot as shown in the illustration below until it emerges between the platen and the ribbon guide. Then pull up the paper until the perforation between the first and second pages is even with the top of the printer's ribbon. Continuous Paper with the Pull Tractor (2/4) EPSON FX-85/FX-1180+ Quick Guide 7. Fit four holes of the paper over the tractor pins on both sprockets. Remove any slack in the paper by pressing the LF/FF button. c Caution: Always remove any slack from the paper; otherwise print quality may deteriorate. 8. Slide the right sprocket to remove any slack in the paper, then lock it in place. Open the edge guides on the paper guide all the way to the left and right, then raise the continuous paper support. 13. When the printer receives data, it will start printing at the current position without advancing the paper. If necessary, follow the steps in "Micro Adjust Function" to adjust the current position of the paper. c Caution: Never use the knob to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position. 14. Attach the printer cover by inserting the front tabs into the slots on the printer, then lowering the cover into place. Slide the paper support midway between the paper guides. c Caution: Do not load multipart forms, carbon paper, envelopes, or labels in the single-bin cut-sheet feeder. 1. Paper support Single Sheets with the Single-Bin Cut-Sheet Feeder (1/2) EPSON FX-85/FX-1180+ Quick Guide 3. Pull both paper set levers forward until the paper guides retract and lock open to allow paper loading. Attach the stacker-support wires to the paper guide as shown below, if necessary. 4. Take a stack of paper (up to 50 sheets) and fan it. Next, tap the side and bottom edges of the paper on a flat surface to even up the stack. Insert the paper stack printable side down along the left paper guide. 9. Install the paper guide with the attached stacker-support by fitting the notches on the paper guide straight down over the mounting posts on the printer. Slide the edge guides to the middle of your paper. 6. Adjust the right paper guide so that it matches your paper's width. Make sure the position of the guide allows the paper to move up and down freely. [. . . ] If necessary, adjust the top-of-form position in your software. (If the tractor is in a push position, press the Load/Eject button to advance continuous paper to the current top-of-form position. ) If necessary, lift up the printer cover so you can see the paper position. Hold down the Pause button for about three seconds. The Pause light starts flashing and the printer enters the Micro Adjust mode. Note: The printer has a minimum and a maximum top-of-form position. [. . . ]