User manual EPSON GT-12000

[. . . ] Scanner Parts document cover document table carriage (at home position) OPERATE button RESET button transportation lock screw ERROR light OPERATE light READY light SCSI interface connectors terminator switch parallel interface connector AC inlet SCSI ID rotary switch option interface connector ® COLOR IMAGE SCANNER All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. No patent liability is assumed with respect to the use of the information contained herein. Neither is any liability assumed for damages resulting from the use of the information contained herein. [. . . ] 2 3-6 Options To scan slides or strips of negative or positive film, see the following section. To scan normal documents with the transparency guide installed, see page 3-13. Using the film holders and reflective document mat Four film holders for scanning film, and a reflective document mat for scanning normal paper documents are included with this unit. To use the guides or mat, see the appropriate section in the following pages. You can easily scan 35 mm slides, strips of 35 mm negative or positive film, and 4 × 5 inch (102 × 127 mm) film using the film holders. See page 3-13 for information on using the document mat to scan normal documents with the Transparency Unit installed. Options 3-7 Note: u Wipe the glass of the Transparency Unit, the scanner's document table, and the narrow window near the mounting bracket with a soft, dry cloth before scanning transparencies. u Your scanner software automatically controls the operation of the Transparency Unit. Loading 35 mm slides 1. Load slides in the 35 mm slide holder face down, as shown below. Repeat this step for all the slides you scan. 2. Place the slide holder on the document table. Align the slide holder with the notch on the transparency guide, as shown below. 3-8 Options Loading strips of negative or positive film 1. Place the 35 mm filmstrip holder on a flat surface, and remove a strip cover. 2. Insert a strip of film in the filmstrip holder face down. 61 004L Options 3-9 3. Replace the strip cover that you removed in step 1. Repeat steps 1 through 3 for all the filmstrips you scan. 4. Place the filmstrip holder on the document table and align it with the notch on the transparency guide as shown below. Loading medium format film 1. Place the medium format film holder on a flat surface, and open a strip cover. 3-10 Options 2. Insert the film in the holder face down. 3. Repeat steps 1 through 3 for all the film you scan. 4. Place the holder on the document table, and align it with the notch on the transparency guide, as shown below. Options 3-11 Loading 4" × 5" film 1. Place the 4" x 5" film holder on a flat surface, and open a cover. 2. Insert the film in the holder face down. 3. Repeat steps 1 through 3 for all the film you scan. 3-12 Options 4. Place the holder on the document table, align it with the notch on the transparency guide, as shown below. Loading normal documents with the Unit installed To scan normal documents with the Transparency Unit installed, always insert the reflective document mat included with this unit as described below. Open the Transparency Unit and remove the transparency guide from the scanner's document table if necessary. [. . . ] There is also technical information including details of the latest software and drivers available. Phone (02) 9903 9075 and the system will guide you through a number of choices before faxing the information to your fax machine. EPSON Bulletin Board System This is where you can download the latest software and drivers. Visit the BBS to check out the latest versions. If you have a modem, phone (02) 9417 5090. Internet URL http://www. epson. com. au Access the EPSON Australia World Wide Web pages. [. . . ]