User manual EPSON LABELWORKS LW-300

[. . . ] Before use Part Names and Functions 2. Remove the slack of the ink ribbon. Display Settings ("Display" menu) 21 20 19 18 17 16 15 14 13 12 11 10 User’s Guide This product operates on batteries or with the dedicated AC adapter. 1. Feeding the tape c Using on batteries Do not press the "Cut Button" before the tape stops. 1 2 3 4 5 6 7 8 9 c Prepare six AAA alkaline batteries. 1. Remove the cover on the rear. After setting a tape cartridge, make sure to feed tape. [. . . ] AC adapter: Disconnect from the outlet and the product.  Usage conditions 10 to 35 degrees C -10 to 55 degrees C Battery  Operating temperature Storage temperature Supported tape width DANGER 6 mm, 9 mm, 12 mm When handling batteries If liquid leaking from an alkaline battery gets into your eyes, do not rub your eyes but immediately wash them well with clean water and contact a doctor. Otherwise, it may cause blindness. Troubleshooting  Messages Insert Tape No tape cartridge is installed. Turn the power off and install a tape cartridge correctly. Check battery Possible causes for this message are: • No power remaining or inserted in the wrong way • Mixed with other types or old ones If so, set the batteries correctly or replace them with new ones. Too many lines Text entered is too long. Press to delete the lines indicated by the cursor. only 1 Sequence numbers have already been set. Sequence numbers can be used for one part only. Entered text is too long for the specified tape length. Turn the power off and take out the tape cartridge. Wait for a while before start printing again. If you open the cover on the rear without turning the power off, a message is displayed and then the power is turned off automatically. An error occurred in the motor operation. Turn the power off once, then turn it back on. If the same message appears, turn the power off and contact the EPSON customer support centre. Editing characters Press character keys and enter text. sPart Names and Functions Text is entered from the cursor position. sDisplay Select from the following two methods. Available marks  Adding a punctuation mark to the label Useful functions This section explains various functions that will help you create labels.  Changing the font size  Adding a frame WARNING When using the AC adapter and power cable Do not use any AC adapter or power cable other than the dedicated AC adapter and power cable. Do not use the AC adapter with other than the specified voltage also. Otherwise, damage, overheating, fire or electric shock may occur. Take the following precautions when handling the AC adapter and power cable. • Make sure to avoid octopus wiring. [. . . ] Select "Narrow" with , and press , and press . c Styles applied to small or elaborate characters may not be able to print clearly.  Lining up characters vertically MEMO Tape cartridges contain ink ribbons in them. When disposing tape cartridges, make sure to follow the local regulations for disposal.  Other cautions Display has turned off. Did you enable the auto power-off function? [. . . ]