User manual EPSON LQ-2500+ ESCP MANUAL

[. . . ] Insert the printer software CD-ROM into the CD-ROM drive. Note: If the Installer dialog box does not appear, double-click Setup. exe in the CD-ROM. Click Browse to select appropriate path for the printer driver, then click OK and follow the instructions on the screen. Note: If you are using Windows NT 4. 0, insert your Windows CD-ROM when prompted on the screen. [. . . ] When prompted, insert the Printer Driver Software CD-ROM, then click Browse to select appropriate path. Note: If you receive a message saying the drive is not accessible, click Cancel and try again. If a "System Error" message appears, click Cancel. The exact message differs depending on your version of Windows. If you are using Windows NT 4. 0, you do not need to specify a path. If you are using Windows 98, Printer Utility Setup may start. If it does, follow the instructions on the screen. You are ready to use. For Windows 98, 95, or NT 4. 0 users Note: Installing the printer software for Windows NT 4. 0 may require administrator privileges. If you have problems, ask your administrator for more information. The examples in the following section are from the Windows 98 operating system. Remove and reload your paper correctly, then press the Pause button. See Paper Handling in the online Reference Guide for paper-loading instructions. Press the Load/Eject button to eject the sheet. n Power n Pause o Paper Out ··· The paper release lever is set to the wrong position. Set the paper release lever to the position for the paper source you want to use. If paper from another paper source is currently in the paper path, press the Load/Eject button to eject the paper; then move the paper release lever to the desired position. o = off, n = on, f = flashing Replacing the Ribbon Cartridge ··· = short series of beeps (three beeps) w 1. 4. Warning: If you have just used the printer, the printer may be hot; let it cool for a few minutes before touching it. When printing becomes faint, you need to replace the ribbon cartridge. Make sure the printer is turned off and unplugged. Hold the ribbon guide and move the print head slightly to the left. Remove the ribbon cartridge by pulling the ribbon guide and then the body of the cartridge forward. [. . . ] Remove the ribbon cartridge by pulling the ribbon guide and then the body of the cartridge forward. Follow steps 5 - 10 in the Assembling the Printer section on the front of this Setup Guide. Note: EPSON recommends the use of genuine EPSON ribbon cartridges (S015290). All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. [. . . ]