User manual EPSON MOVIEMATE 25

[. . . ] Epson MovieMateTM 25 ® User's Guide CPD-20183 Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson product. Epson is not responsible for any use of this information as applied to other products. [. . . ] Remove the old filter and install the new filter. 40 Caring for MovieMate 5. Replace the cover. Replacing the Lamp The life span of the lamp is about 3000 hours if the color mode is consistently set to Theatre Black, and 2000 hours if any other color mode is used. For instructions on changing the color mode, see page 21. You can check how long the lamp has been used, as described on page 34. If the number shown is close to the limit, make sure you have a spare lamp handy. Note: Lamp life results vary depending on environmental conditions and usage. Continuous 24-hour-a-day use may reduce the overall life of the entire product. It's time to replace the lamp when: Lamp light The projected image gets darker or starts to deteriorate. The message Replace the lamp appears on the screen when you start projecting. Caution: If you continue to use the lamp after you see the replacement indicators, the lamp is more likely to break. You can purchase a new lamp (part # V13H010L33) from an authorized Epson reseller. To find the nearest reseller, call 800-GO-EPSON (800-463-7766). In the U. S. , you can also purchase online at www. epsonstore. com. In Canada, you can also purchase at www. epson. ca or (800) 807-7766. Be sure to read the "Important Safety Information" on page 57 before replacing the lamp. Follow these steps to replace the lamp: 1. Turn off the main power switch and disconnect the power cord. If the projector has been on, let it cool for at least an hour. Warning: Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury. Insert a small screwdriver into the lamp cover release slot, pushing it in gently to release the lamp cover. . 4. Loosen the two silver screws holding the lamp in place. (You can't remove these screws. ) 5. Grasp the lamp as shown and pull it straight out. Note: The lamp in this product contains mercury. Please consult your state and local regulations regarding disposal or recycling. Gently insert the new lamp and tighten its screws. Caution: Don't touch the glass portion of the lamp with your bare hands; the invisible residue left by the oil on your hands may shorten the lamp life. Use a cloth or gloves to handle the new lamp assembly. 42 Caring for MovieMate 7. [. . . ] Epson will, at its option, repair or replace on an exchange basis the defective unit, without charge for parts or labor. When warranty service involves the 60 Specifications and Notices exchange of the product or of a part, the item replaced becomes Epson property. The exchanged product or part may be new or previously repaired to the Epson standard of quality, or, at Epson's option, may be another model of like kind and quality. Exchange or replacement products assume the remaining warranty period of the product covered by this limited warranty, except that each replacement lamp carries the limited 90-day warranty stated above. [. . . ]