User manual EPSON MOVIEMATE 30S

[. . . ] Epson MovieMateTM 30s Series User's Guide Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson product. Epson is not responsible for any use of this information as applied to other products. [. . . ] Press or to increase or decrease the setting. The settings are saved, even after you turn MovieMate off. Viewing and Adjusting Video Information You can use the Visual Info. button on the remote control to view the number of hours the lamp has been used, and to reset the timer after you install a new lamp. You can also adjust the video signal setting and select high altitude mode if necessary. You see the following on the screen: Note: If the lamp has been used less than 11 hours, 0H is displayed. 2. Continue pressing the button until you see the item you want to set. You can adjust the following items: Video Signal: If you are using external video equipment and you see interference or other problems, select the appropriate signal for your equipment. For most purposes, leave this setting on Auto. High Altitude Mode: If you are using MovieMate at an altitude above 4, 900 feet (1500 meters), select ON. Lamp-Hours Reset: After you replace the lamp, select Yes to reset the lamp timer. 3. Press the or to change the setting. button to save your settings and exit. Disabling Progressive Mode For the best image quality, MovieMate uses progressive video display mode. You can change to interlaced mode if the picture appears jittery, for example, when you use certain external equipment. To change from progressive to interlaced display mode, press . Doing More with MovieMate 45 Changing the Display Window Brightness The status display window above the tray is normally dimmer when a DVD is playing and brighter when it is paused or stopped. To change the display window setting, press from the following settings: . Continue pressing the button to select DIMMER OFF: The window remains bright, even when a DVD is playing. DIMMER ON: The window remains dim, even when a DVD is not playing. DIMMER AUTO: The window is dimmer when a DVD is playing and brighter when it is paused or stopped. 46 Doing More with MovieMate Caring for MovieMate MovieMate 30s needs little maintenance. All you need to do on a regular basis is keep the lens clean. You also need to clean the air filter periodically to prevent overheating. Warning: Before you clean any part of MovieMate, turn it off and unplug the power cord. Never open any part of MovieMate, except as described in this User's Guide. Dangerous electrical voltages in the projector can injure you severely. Do not try to service this product yourself, except as specifically explained in this User's Guide. The only parts you should replace are the lamp and air filter. If another part needs replacing, contact Epson or a qualified servicer (see page 62). Follow the instructions in this section to clean the lens and case, clean and replace the air filter, replace the lamp, and store or transport MovieMate. Protecting MovieMate The Epson MovieMate projector is designed for use virtually anywhere at home. [. . . ] However, each replacement lamp carries the limited 90-day warranty stated above. What This Warranty Does Not Cover: This warranty does not apply to refurbished or reconditioned products. This warranty covers only normal use of the product. 24-hour-per-day or other high duty commercial use causes strain and is not considered normal use. [. . . ]