User manual EPSON POWERLITE 6100I

[. . . ] Epson PowerLite 6100i Multimedia Projector ® ® User' Guide s Important Safety Information WARNING: Never look into the projector lens when the lamp is turned on; the bright light can damage your eyes. Never let children look into the lens when it is on. Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical voltages inside the projector can severely injure you. [. . . ] See "Where To Get Help" on page 109. 2. To protect your logo from being changed or disabled, select User's Logo Protect and press Enter. Press Menu to exit the Password Protect menu. If you lose the remote control, you will not be able to enter the password, so keep the remote control in a safe place at all times. Configuring the Projector 69 note If you are prompted for a password, press and hold down the Num key on the remote control while you use the numeric keypad to enter the password. If you enter the password incorrectly three times in succession, the projector's operation is locked and you'll need to turn it off and disconnect the power cord, then reconnect it. If an incorrect password is entered 30 times in succession, the projector is locked and you'll need to contact Epson to unlock it. See "Where To Get Help" on page 109. Turning on Password Protection If you enable the Power On Protect setting, a screen appears requesting the password whenever the projector is turned on. If you loan the projector to someone, but you want to make sure that the they return it by a certain time, you can disable the password for a set period of time. When that time has elapsed, the password is reactivated and must be entered before the projector can be used. Make sure that you've set a password for the projector as described on page 68. Press and hold down the Freeze button until you see the Password Protect menu: 2. Select Power On Protect and press Enter. Press Esc to return to the Password Protect menu. note The countdown for the elapsed time begins as soon as you close the Password Protect menu. (You can check the elapsed time in this menu next to Time-elapsed. ) If you want the projector to request the password every time it is turned on, set the Timer to 0H. 4. If you want to disable the password temporarily, select Password Timer and press Enter. Press Esc to return to the Password Protect menu. Hold down the Num button on the remote control while you use the numeric keypad to enter the number of hours to disable the password for, then press Enter. When the period defined in the Timer setting has passed, and the password is entered correctly, the elapsed time will be reset to 0 and the countdown will start again. Remember to disable or change this setting when you need to. If you lose the remote control, you will not be able to enter the password, so keep the remote control in a safe place at all times. 70 Configuring the Projector Starting the Projector with a Password When the password function is enabled, you see a password entry screen when you turn on the projector. Press down the Num button on the remote control as you use the numeric keypad buttons to enter the password. Once you have entered the password correctly, the password screen closes, and projection begins. [. . . ] However, each replacement lamp carries the limited 90-day warranty stated above. What This Warranty Does Not Cover: This warranty does not apply to refurbished or reconditioned products. This warranty covers only normal use of the product. 24-hour-per-day or other excessive continual use causes strain and is not considered normal use. [. . . ]