User manual EPSON POWERLITE 7800P

[. . . ] EPSON PowerLite 7800p Multimedia Projector ® ® User's Guide Important Safety Information WARNING: Never look into the projector lens when the lamp is turned on; the bright light can damage your eyes. Never let children look into the lens when it is on. Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical voltages inside the projector can severely injure you. [. . . ] To operate a projector, you have to set the remote control's ID to match that of the projector. Or you can control all of the projectors simultaneously by setting the remote control's ID to zero. Setting the Projector ID The projector's default ID is 1. If you need to change it, follow these steps: 1. Press the Menu button on the remote control. You see the projector's menu screen. Select the Advanced2 menu and press Enter. Then highlight Projector ID and press Enter. Video Audio Effect Setting User's Logo Advanced1 Advanced2 About Reset All Brightness Control : High Projector ID Network COM Port Auto setup Low Set Set :1 : RS-232C USB : ON OFF BNC Sync Termination : ON OFF Reset Execute [ ESC ]: Return [ / ]: Select [ ]: Set [Menu]: Exit 3. Press the right or left side of the decrease the ID value. Press Enter to set the value. pointer button to increase or 5. When done, press ESC to exit the menu system. 60 Giving Your Presentation Setting the Remote Control ID The remote control's default ID is zero. If you need to change it, follow these steps: 1. Press the ID button on the remote control. Press one of the numbered buttons on the remote control to select the desired ID (0 through 9). Select zero to control all projectors, or select a number to match the ID of the projector(s) you want to operate. Nine Zero The ID button's light shuts off and the new ID is registered. If you would like to check the remote control's current ID, do the following: 1. Press the ID button twice in succession. Count the number of flashes; this number corresponds to the remote control's ID. (If it doesn't flash, the ID is set to zero. ) Giving Your Presentation 61 62 Giving Your Presentation 1 Fine-tuning the Projector can use the projector's on-screen menus to adjust the image, sound, and other features. This chapter covers the following information: You Using the menu system Adjusting the image quality Adjusting the image size, shape, and position Adjusting the color Adjusting the sound Customizing projector features Fine-tuning the Projector 63 Using the Menu System You can use the remote control (or the projector's control panel) to access the menus and change settings. To display the menu screen, press the Menu button. You see a menu screen similar to the one shown below (the settings may differ from those shown here, depending on the selected input source): Options Menu list Video Audio Effect Setting User's Logo Advanced1 Advanced2 About Reset All Position Adjust : 0000 Tracking Sync. : 0 + Brightness : 0: Auto Manual Contrast Adjust + Sharpness : 0Color Mode Select [Presentation ] Select Resolution : Auto Manual : [ Set Execute ] note You can also use the buttons on the projector to access the menu system: Menu button ESC button [ ]: Select [ ]: Enter Preset Reset [Menu]: Exit The menus are listed on the left, and the options available for the highlighted menu are shown on the right. [. . . ] EPSON will, at its option, repair or replace on an exchange basis the defective unit, without charge for parts or labor. When warranty service involves the exchange of the product or of a part, the item replaced becomes EPSON property. The exchanged product or part may be new or previously repaired to the EPSON standard of quality. Exchange or replacement products or parts assume the remaining warranty period of the product covered by this limited warranty. [. . . ]