User manual EPSON POWERLITE 810P

[. . . ] EPSON PowerLite 600p/800p/810p Multimedia Projector ® ® User' Guide s Important Safety Information WARNING: Never look into the projector lens when the lamp is turned on; the bright light can damage your eyes. Never let children look into the lens when it is on. Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical voltages inside the projector can severely injure you. [. . . ] You can also use it as the screen displayed when the projector is not receiving a signal or when you press the A/V Mute button. The image can be a company logo, slogan, photograph, or any other image you want to use. Capturing the Image Start by displaying the image you want to use. It can be an image from either a computer or video source such as a DVD player or digital camera. Then follow these steps to capture the image and transfer it to the projector: 1. Press the Menu button on the control panel or remote control. You see the menu screen. Sync­ button (control panel) or the button 2. Use the (remote control) to highlight the User's Logo menu, then press . User's Logo Capture Do you use the present image as a user's logo?When you see the screen shown at right, select Yes and press A selection box displays over the image. . :Return :Select :Execute Fine-tuning the Projector 51 4. Use the Tracking and Sync buttons (control panel) or the button (remote control) to select the area of the image you want to use. When you see the message "Do you use this image?" select Yes and press . User's Logo Capture You see the screen shown at the left. Use the Tracking and Sync buttons (control panel) or the button (remote control) to select a zoom rate (display size), and then press . When the message "Do you save the user's logo?" appears, select Yes and press . Do not use your projector or video source (computer, DVD player, etc. ) while the logo is being saved. When you see the message "Saving the user's logo is completed, " press Esc to return to the menu screen. Set the zoom rate. zoom rate : 100 200 300 :Return :Select :Execute Choosing When to Display the Image note You can also set up your image as the startup screen using the Advanced menu; see page 55. After your image is saved, you can set it up as the no-signal message and/or the screen that's displayed when you press A/V Mute. Press the Menu button to display the menu screen (if not already displayed). Sync­ button (control panel) or the 2. Use the (remote control) to highlight the Setting menu. button 3. Press the button to select the Setting menu. Sync­ button (control panel) or the button 4. Use the (remote control) to highlight either No-Signal Msg. or A/V Mute, depending on when you want the image to display. Tracking+ button (control panel) or the button 5. Use the (remote control) to select Logo. [. . . ] This warranty does not cover consumables (e. g. , fuses), other than lamps. EPSON is not responsible for warranty service should the EPSON label or logo or the rating label or serial number be removed or should the product fail to be properly maintained or fail to function properly as a result of misuse, abuse, improper installation, neglect, improper shipping, damage caused by disasters such as fire, flood, and lightning, improper electrical current, software problems, interaction with non-EPSON products, or service other than by an EPSON Authorized Servicer. Postage, insurance, or shipping costs incurred in presenting your EPSON product for carry-in warranty service are your responsibility. If a claimed defect cannot be identified or reproduced in service, you will be held responsible for costs incurred. [. . . ]