User manual EPSON POWERLITE CINEMA 200

[. . . ] EPSON PowerLite Cinema 200 Home Theater Projector ® ® User's Guide Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON product. EPSON is not responsible for any use of this information as applied to other products. [. . . ] Select Picture Quality, then click Memory management and choose Edit. Select the setting you want to delete, then click Memory Reset and confirm the deletion. 48 Maintenance Your projector needs little maintenance. All you need to do on a regular basis is keep the lens clean. You also need to clean the air filter periodically to prevent overheating. Warning: Before you clean any part of the projector, turn it off and unplug the power cord. Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical voltages in the projector can injure you severely. Do not try to service this product yourself, except as specifically explained in this User's Guide. The only parts you should replace are the lamp and air filter. If another part needs replacing, contact your dealer or a qualified servicer. Cleaning the Lens Clean the lens whenever you notice dirt or dust on the surface. Use a canister of compressed air to remove dust. To remove dirt or smears, use lens-cleaning paper. If necessary, moisten a soft cloth with lens cleaner and gently wipe the lens surface. Caution: Never rub the lens with abrasive materials. Cleaning the Projector Case Before you clean the case, turn off the projector and unplug the power cord. To remove dirt or dust, wipe the case with a soft, dry, lint-free cloth. To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral detergent. Then wipe the case. Caution: Never use wax, alcohol, benzene, thinner, or other chemical detergents. These can damage the case. 49 Changing the Remote Control's Batteries The remote control uses two AA batteries. If you suspect they are weak, take the remote control to a darkened room and press the illumination button. If the buttons on the remote control do not glow red, replace the batteries as described below. Warning: Keep batteries away from children. If a battery should be swallowed, contact your doctor immediately. 1. Release the tab and lift open the cover. 2. Remove the old batteries and insert the new AA batteries as shown. 3. Replace the cover. 50 Cleaning and Replacing the Air Filter Clean the air filter on the bottom of the projector after every 100 hours of use. If it's not cleaned periodically, it can become clogged with dust, preventing proper ventilation. This can cause overheating and damage the projector. Turn off the projector and wait for the P power light to stop flashing. [. . . ] If your projector is being repaired by carry-in warranty service, please bring the product securely packaged in its original container or an equivalent to your EPSON Dealer or EPSON Customer Care Center. EPSON will, at its option, 72 repair or replace on an exchange basis the defective unit, without charge for parts or labor. When warranty service involves the exchange of the product or of a part, the item replaced becomes EPSON property. The exchanged product or part may be new or previously repaired to the EPSON standard of quality, or, at EPSON's option, may be another model of like kind and quality. [. . . ]