User manual EPSON STYLUS COLOR 1160

[. . . ] EPSON Stylus COLOR 1160 ® Printer Basics Printed on recycled paper with at least 10% post-consumer content. Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON printer. EPSON is not responsible for any use of this information as applied to other printers. [. . . ] The nozzle check pattern prints (see page 40 for details). 38 7. If the nozzle check pattern has no gaps in its dots, click Finish. If the pattern is missing dots, click Clean to clean the print head again. If you don't see any improvement after cleaning three or four times, check the solutions in "Problems Getting Good Print Quality" on page 55. You can also turn the printer off and wait overnight--this allows any dried ink to soften--and then try cleaning the print head again. Using the Control Panel to Clean the Print Head Follow the steps below to clean the print head. (See page 49 for more control panel information. ) 1. Make sure the printer is turned on but not printing, and both the B black and A color ink out lights are off. (If an ink out light is flashing, replace the ink cartridge before continuing. ) 2. Press the R cleaning button and hold it down for three seconds. Cleaning takes about 30 seconds, during which the printer makes some noise and the Ppower light flashes. cleaning button Never turn off the printer while the Ppower light is flashing, unless the printer hasn't moved or made noise for more than 5 minutes. 3. After the Ppower light stops flashing, print a page to test the print quality. If your printer is connected directly to the computer, go to step 4 to run a nozzle check. If you're printing over a network, open an application and print a short document containing black and color data. Check the quality of your printout, then go to step 8. If you have an application running, access the printer settings dialog box as described on page 15 (Windows) or page 20 (Macintosh). 39 Or, with Windows, click Start, point to Settings, then select Printers. Right-click the EPSON Stylus COLOR 1160 printer icon in the Printers window. Then select Properties (Document Defaults in Windows NT). Macintosh: Click the Utility button. 6. Make sure paper is loaded in the printer, click the Nozzle Check button, and click Next. The nozzle check pattern prints (see the next section for details). If the nozzle check pattern has no gaps in its dots, click Finish. If the pattern is missing dots, click Clean to clean the print head again. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. [. . . ]