User manual EPSON STYLUS COLOR 740

[. . . ] Characters available with ESC ( ^ command . Most DOS software programs include a driver for EPSON ESC/P 2TM printers, and require you to select the printer name from a list to install the printer driver. To take advantage of your printer's advanced built-in scalable fonts and graphics handling, you need to select an appropriate driver. If your printer is not included in the list, contact your software manufacturer to obtain updated software. [. . . ] If you're printing on glossy media or transparencies, place a support sheet (or a piece of plain paper) beneath the stack, or load one sheet at a time. Ink may have leaked inside the printer; wipe the inside of the printer as shown below with a soft, clean cloth. If any of the following problems have occurred, see the solutions given below. T t t Press the P power button and make sure the printer is on. Turn off the printer and make sure the power cord is plugged in securely. Make sure the power outlet is working and is not controlled by a wall switch or timer. Lights came on and then went out Only the power light is on Try one or more of these solutions: t t t Turn off the printer and computer. make sure the printer's interface cable is plugged in securely. Make sure there's no packing material in the printer. If it prints, make sure the printer software and your application software is installed correctly. Note: If you're trying to print a large image, your computer may not have enough memory to print. T If the above doesn't work, replace the ink cartridges. If the S paper out light is on, load more paper in the sheet feeder. Turn the printer off, wait a few seconds, and then turn it on again. If the lights still flash, turn the printer off and check the inside of the printer for any foreign objects or pieces the paper. Remove all foreign objects and paper, then turn on the printer again. If any of the following problems have occurred, see the solutions given below. Remove the stack of paper and check that: t t t t The paper isn't curled or creased. See the instructions that came with the paper for more information. The paper isn't loaded above the arrow on the left edge guide. Remove the stack of paper and: t t Make sure the paper is not too thin. Turn off your printer, open the cover, and remove all the paper from inside, including any torn pieces. [. . . ] Make sure that the printer is on and the B and A ink out lights are off. Note: The print head cannot be cleaned if the B or A ink out light is flashing or on. The P power light begins flashing, and the printer ejects any paper in the paper path and starts cleaning the print head. This operation takes about two minutes to complete. [. . . ]