User manual EPSON STYLUS COLOR 850N

[. . . ] User's Guide Printed on recycled paper with at least 10% post-consumer content All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON printer. EPSON is not responsible for any use of this information as applied to other printers. [. . . ] The print heads move slightly left and the Ppower light begins flashing. (The print heads return to their home position if you don't proceed to step 5 within 60 seconds. ) 5-2 Maintenance and Transportation 5. (Although the illustration shows the black ink cartridge, the procedure is the same for replacing the color ink cartridge. ) Caution: Don't open the clamp or remove a cartridge except to replace it with a new one. Once you remove a cartridge, you can't reuse it, even if it contains ink. Warning: If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. 6. Lift the cartridge out of the printer and dispose of it carefully. Follow the steps in the next section to install the new ink cartridge. 5-3 Maintenance and Transportation Installing the New Cartridge Once you have removed the empty cartridge, you're ready to install the new one. Remove the new ink cartridge from its packaging. Remove only the yellow part of the tape seal on top as shown below. Don't pull off the white portion or try to remove the clear seal underneath the cartridge. Caution: You must remove the yellow tape from the top of the cartridge or you will permanently damage it. It's okay if the tape doesn't tear off completely at the dotted line. Do not remove the clear seal from the bottom of the cartridge; ink will leak out. black cartridge color cartridge 3. Lower the ink cartridge into its holder with the label facing up and the arrow pointing to the back of the printer. 4. Press down the ink cartridge clamp until it locks in place. 5-4 Maintenance and Transportation 5. If you need to replace the other ink cartridge, follow the steps under "Removing an Empty Ink Cartridge, " and then steps 1 through 4 under "Installing the New Cartridge. " 6. Press the E load/eject button and close the printer cover. The printer moves the print heads and begins charging the ink delivery system. (Even if you don't press the button, ink charging begins 60 seconds after you close the clamp. ) Caution: Never turn off the printer while the Ppower light is flashing, unless the printer hasn't moved or made any noise for more than 10 minutes. The Ppower light flashes, and the printer makes various sounds. When it's finished, you can print again. Replacing an Outdated Ink Cartridge If an ink cartridge is more than six months old, you may need to replace it. You may notice that your printouts don't look as good as they used to. If print quality doesn't improve after cleaning and aligning the print heads, you can replace one or both cartridges. [. . . ] The card can act as a print server when it is in print server mode, selectable through Novell NetWare. The area of a page on which the printer can print. It is smaller than the physical size of the page because of margins. Printing in which the width of the character varies from character to character. [. . . ]