User manual EPSON STYLUS OFFICE T30

[. . . ] Problem Solver helps you fix common printing problems when you encounter them. Test Print lets you print a test page to check the results of settings you have made and provides links to other sections of EPSON Answers based on the results. Color Guide explains the ABC's of color printing and shows you how to get impressive results from your printer. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORP. [. . . ] Note: u The printer automatically moves the print head back to its home (far right) position after about 60 seconds if you have not started the replacement procedure. If you hold down the eaning button when both and ink out lights are off, the printer starts cleaning the print head. Caution: Do not move the print head by hand. Always use the cleaning button to move it. When you do, the cartridge will rise partly out of the cartridge holder. The following illustration shows color ink replacement. Do not take the used cartridge apart or try to refill it. Warning: If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. Caution: Leave the old cartridge installed in the printer until you are ready to replace it with a new one. Next, remove only the yellow tape seal from the cartridge as shown below. If you need to transport your printer some distance, carefully repack it using the original box and packing materials as follows: 1. Open the printer cover and make sure that the print head is in the home (far right) position. If not turn on the printer and wait until the print head returns to the home position. Turn off the printer and then close the printer cover. Removing the cartridges during transport can damage the printer. Unplug the power cord from the electrical outlet; then disconnect the interface cable from the printer. Remove the paper from the sheet feeder and remove the paper support. Push in the output extension tray, and then raise the output tray. Keep the printer level during transport. Troubleshooting printer problems is best handled in two easy steps: first diagnose the problem, then apply likely solutions until the problem is fixed. The information that you need to diagnose the most common problems is provided by the printer's control panel lights and by the EPSON Status Monitor utility (Windows 95 only). [. . . ] This happens every time you turn on the printer or reset the printer. A method of printing in which each letter or symbol is formed by precisely spraying ink onto paper. The position to which the paper is automatically loaded. Materials upon which data is printed, such as envelopes, plain paper, special paper, and transparency film. [. . . ]