User manual EPSON STYLUS PHOTO 830 SETUP GUIDE

[. . . ] The printer resumes printing and the light goes out. Setting up Installing the Printer Software Note: For installing the Photo Print Software, refer to the Photo Print Software Setup on the online Reference Guide. The EPSON's Technical Support Web Site provide you with tips to help solve problems. Access the Technical Support in the following ways: Ob For Windows users Installing the Ink Cartridges 1. Do not remove the blue portion of the tape seal from the top of the cartridge. You can also access them by clicking Technical Support in the Status Monitor 3 dialog box or on the Main menu of the printer software. Ob Paper jam Paper has jammed in the printer. For further information on the customer support services available in your area, see the online Reference Guide. Press the b maintenance button to eject the jammed paper. [. . . ] If the error does not clear, contact your dealer. kP kb Unknown printer error An unknown printer error has occurred. Turn off the printer and contact your dealer. O O = on, N = off, k k = flashing 4. Press the e ink cartridge replacement button. For Mac OS X users 1. Insert the printer software CD in the CD-ROM drive. Double-click the Mac OS X Driver folder, and then double-click the SP830Series. pkg icon inside it. The printer begins ink charging. While charging, the printer produces a variety of mechanical sounds. When the green lamp stops flashing, ink charging is complete. Safety Instructions Read all of the instructions in this section when setting up and using your printer. When choosing a place for the printer Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer away from direct sunlight, strong light, or heat sources. Avoid places subject to dust, shocks, and vibrations. Leave enough room around the printer to allow for sufficient ventilation. Place the printer near a wall outlet where the plug can be easily unplugged. Place the printer on a flat, stable surface that extends beyond the printer base in all directions. If you place the printer by the wall, leave more than 10 cm between the back of the printer and the wall. The printer will not operate properly if it is tilted at an angle. When storing or transporting the printer, do not tilt it, put it vertically or turn it upside down; otherwise, ink may leak from the cartridge. The IC chip on this ink cartridge retains a variety of cartridge related-information, such as the amount of ink remaining, so that a cartridge may be removed and reinserted freely. However, each time the cartridge is inserted, some ink is consumed because the printer automatically performs a reliability check. When using the printer Do not put your hand inside the printer or touch the ink cartridges during printing. Do not block or cover the openings in the printer's cabinet. Do not attempt to service the printer yourself. Unplug the printer and refer servicing to qualified service personnel under the following conditions: The power cord or plug is damaged; liquid has entered the printer; the printer has been dropped or the cabinet damaged; the printer does not operate normally or exhibits a distinct change in performance. [. . . ] Do not shake the ink cartridges; this can cause leakage. You must remove the yellow tape seals from the cartridges before installing them; otherwise, the cartridges will become unusable. Do not remove the blue portion of the tape seal from the top of the cartridges. [. . . ]