User manual EPSON STYLUS PHOTO 830U SETUP GUIDE

[. . . ] Install the ink cartridges as shown below. Caution: Do not shake the ink cartridges; this can cause leakage. Follow the on-screen instructions. After installing the software and restarting the computer, turn on the printer. Select your printer and the port that your printer is connected to, then close the chooser. For Mac OS X 1. Open the Mac OS X folder, then double-click the SP830USeries_xxxx. pkg icon. [. . . ] Leave enough room around the printer to allow for sufficient ventilation. Place the printer near a wall outlet where the plug can be easily unplugged. Place the printer on a flat, stable surface that extends beyond the printer base in all directions. If you place the printer by the wall, leave more than 10 cm between the back of the printer and the wall. The printer will not operate properly if it is tilted at an angle. When storing or transporting the printer, do not tilt it, put it vertically or turn it upside down; otherwise, ink may leak from the cartridge. The IC chip on this ink cartridge retains a variety of cartridge related-information, such as the amount of ink remaining, so that a cartridge may be removed and reinserted freely. However, each time the cartridge is inserted, some ink is consumed because the printer automatically performs a reliability check. When using the printer Do not put your hand inside the printer or touch the ink cartridges during printing. Do not block or cover the openings in the printer. Do not attempt to service the printer yourself. Unplug the printer and refer servicing to qualified service personnel under the following conditions: The power cord or plug is damaged; liquid has entered the printer; the printer has been dropped or the cabinet damaged; the printer does not operate normally or exhibits a distinct change in performance. Do not insert objects through the slots in the printer. Take care not to spill liquid on the printer. Removing the cartridges can dehydrate the printer head and may prevent the printer from printing. Mac OS 8. 6 to 9. X 2 1 When choosing a power source Use only the type of power source indicated on the printer's label. Be sure your AC power cord meets the relevant local safety standard. Do not use a damaged or frayed power cord. If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure that the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating. If you plan to use the printer in Germany, the building installation must be protected by a 10 or 16 amp circuit breaker to provide adequate short-circuit protection and over-current protection for this printer. Information for United Kingdom Users Use of options EPSON (UK) Limited shall not be liable against any damages or problems arising from the use of any options or consumable products other than those designated as Original EPSON Products or EPSON Approved Products by EPSON (UK) Limited. For Mac OS X 1. [. . . ] EPSON is a registered trademark and EPSON Stylus is a trademark of SEIKO EPSON CORPORATION. Microsoft and Windows are registered trademarks of Microsoft Corporation. Apple and Macintosh are registered trademarks of Apple Computer, Inc. [. . . ]