User manual EPSON STYLUS PHOTO RX600

[. . . ] User's Guide Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson product. Epson is not responsible for any use of this information as applied to other equipment. [. . . ] Make sure the memory card light (next to the card slots) is off and that no cards are inserted. Then insert a card into the correct slot, as shown. CompactFlash or Microdrive (bottom) SD or MMC (middle) MemoryStick (middle) SmartMedia (top) xD (top) The memory card light turns green. Memory card light Note: If the card is not properly formatted, you see a message on the RX600 screen. Press the button indicated on the RX600 screen to format the card. Any data stored on the card will be erased. Scanning Film or Slides to a Memory Card 107 Removing the Film Holder and Document Mat 1. Open the scanner lid and slide out the document mat. Set the mat aside so you can reinstall it for scanning reflective documents later. Note: You can't scan film or slides unless the white document mat is removed from the scanner lid. 2. Remove the film holder from its storage place. (Remember to replace the film holder when you're done using it. ) 3. Continue with one of these sections: "Loading 35 mm Film Strips in the Film Holder" on page 109 (for film) "Placing 35 mm Slides on the Film Holder" on page 110 (for slides) 108 Printing and Scanning Without a Computer Loading 35 mm Film Strips in the Film Holder 1. Remove the cover for the film strip holder. 2. Slide your film strip into the holder with the duller (emulsion) side facing up. The top of the images should be facing the outside edge of the film holder and the images should be reversed. 3. Position the film holder so that the 35 mm film strip faces the center of the scanner glass. The positioning posts on the film holder fit in two small holes near the scanner lid, as shown. Holes Scanning Film or Slides to a Memory Card 109 5. Close the scanner lid. Placing 35 mm Slides on the Film Holder 1. Position the film holder so that the 35 mm slide section faces the center of the scanner glass. The positioning posts fit in two small holes near the scanner lid, as shown. 110 Printing and Scanning Without a Computer 2. Place slides in the film holder as shown, with the duller (emulsion) side facing up. Make sure the top of images with portrait orientation face the front of the RX600 Note: If your slide image is in landscape orientation (wider than it is long), place it in the same direction as slide images in portrait orientation (longer than they are wide). This copies the maximum image area, but your preview will be rotated. 3 Close the scanner lid. Scanning and Saving to Your Memory Card 1. Press the Film Print button to set the RX600 to Film Print mode. Use the u and d buttons to choose Scan to Memory Card. Press the OK button. Scanning Film or Slides to a Memory Card 111 4. [. . . ] If your product is being repaired, Epson will direct you to send your product to Epson or its authorized service center, where the product will be fixed and sent back to you. You are responsible for packing the product and for all costs to and from the Epson authorized service center. When warranty service involves the exchange of the product or a part, the item replaced becomes Epson property. The replacement product or part may be new or refurbished to the Epson standard of quality, and, at Epson's option, may be another model of like kind and quality. [. . . ]