User manual EPSON STYLUS D120 START HERE

[. . . ] The information contained herein is designed only for use with this Epson printer. Epson is not responsible for any use of this information as applied to other printers. Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by the purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U. S. ) failure to strictly comply with Seiko Epson Corporation's operating and maintenance instructions. Seiko Epson Corporation shall not be liable for any damages or problems arising from the use of any options or any consumable products other than those designated as Original Epson Products or Epson Approved Products by Seiko Epson Corporation. [. . . ] Remove the package from an ink cartridge, and then shake the ink cartridge well for best results. No. #1 #2 #3 #4 #5 #6 #7 #8 EPSON Stylus Pro 4800 Matte Black or Photo Black Cyan Magenta Yellow Light Black Light Cyan Light Magenta Light Light Black EPSON Stylus Pro 4400 Matte Black Cyan Magenta Yellow - 6 Loading Roll Paper Attaching the roll paper to the spindle When installing the roll paper onto the spindle, follow the steps below. Slide the movable flange off the end of the spindle. 6. Repeat steps 4 to 5 to install the other ink cartridges. After inserting all ink cartridges in their corresponding slot, lower the ink levers. The printer starts initial ink charging. 2. When attaching roll paper with a 3-inch core, keep the gray attachments attached. When attaching the roll paper with a 2-inch core, remove the gray attachments from the flange. 8. After approximately two minutes, ink lever messages appear on the LCD. Raise or lower the ink levers accordingly until READY appears on the LCD, which indicates initial ink charging is completed. c Caution: Never perform the following tasks while the Pause light is flashing; otherwise, damage may occur. Move the paper lever to the released position. Hold both the fixed and movable flanges, and rewind the paper to the line marked with an arrow mark. 11. Extend the paper tray and the paper tray cover according to the paper length to be used for printing. 3. Lift up the paper tray cover, and then pull the paper guide roller up. 7. Load the sheets with the printable side facing down and the right edge of the paper resting against the right side of the paper tray. 4. Raise the paper guide, and then slide the edge guide to the left slightly wider than the width of your paper. Note: Always set the paper's short edge first. Make sure the sheets lie flat on the bottom of the tray, and put the edge of the paper against the right inner corner of the paper tray; otherwise, printing may become misaligned. The loadable capacity of paper in the paper tray differs depending on the media and its size. The paper tray can hold up to 250-sheets of 17 lb or 64 g/m² plain paper. Do not load the paper above the arrow mark on the inside surface of the left edge guide. For information on the loadable capacity of Epson special media, see the following table. Epson special media Size Loadable capacity in the paper tray 100 100 50 50 5. Fan a stack of paper, and then tap it on a flat surface to even the edges. [. . . ] For IEEE 1394 interface users, click your printer's icon and the FireWire port your printer is connected to. Select the appropriate Background Printing radio button to turn background printing on or off. With background printing on, you can use your Macintosh while it is preparing a document for printing. In order to use the EPSON Monitor IV utility to manage print jobs, background printing must be turned on. [. . . ]