User manual EPSON STYLUS SX620FW

[. . . ] Macintosh computers can only be connected via the USB interface. Depending upon your geographic location, you may need to obtain the appropriate cable. See "Options and Consumable Products" in the Daily Use guide for details. Note: In order to connect your PC via the USB interface, your computer must be a Windows Me, 98 or Windows 2000 pre-installed model that comes with a USB port or Windows Me upgraded from a Windows 98 pre-installed model. Using a parallel interface for Windows users To connect the printer to your PC, you need a shielded, twisted-pair parallel cable. [. . . ] When a message appears informing you that the installation is complete, click Finish. After the setup is complete, proceed to section to print your first page. 2. 3. Installing in Macintosh Follow the instructions in this section to install the printer software, select your printer in the Chooser, and install EPSON PhotoQuicker. ? 1. 2. Caution: Turn off all virus protection programs before you install the printer software. Installing the printer software Follow these steps to install your printer software. Turn on your Macintosh and insert the software CD in the CD-ROM drive. The EPSON printer software CD-ROM opens automatically. If the Install Printer Driver/Utility folder appears in the EPSON folder, open it and then double-click the Installer icon. 3. 4. Note: It is possible to install the Reference Guide on your hard drive from the printer software CD-ROM. To install the guide, click Install Reference Guide and follow the on-screen instructions. When the installation is complete, a View Reference Guide icon appears in the EPSON folder. Double-click the icon to open the guide. It is possible to access Technical Support from the printer software CD-ROM. If ink does get on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. Note: Do not open the ink cartridge packages until just before you install them; otherwise, the ink may dry up. Follow the steps below to install the ink cartridges. Lower the output tray and open the printer cover. 2. ? Turn on the printer by pressing the 2 power button. The print head moves to the left, which is the ink cartridge installation position. The 2 power light flashes and the error light comes on. Caution: Do not move the print head by hand. Doing so may damage the printer. 3. Push back the release tabs and lift up the ink cartridge clamps. 4. 5. Open the ink cartridge packages. Next, remove only the yellow tape seals from each cartridge. Caution: You must remove the yellow tape seals from the cartridges before installing them; otherwise, the cartridges will become unusable and you will be unable to print. If you have installed an ink cartridge without removing the yellow tape seal, you must remove the cartridge and install a new one. [. . . ] Make sure that A4 or Letter size EPSON Photo Quality Ink Jet Paper is loaded in the printer. 2. 3. 4. Insert the printer software CD in the CD-ROM drive. If the Installer dialog box appears, click Quit. Then right-click the CD-ROM drive icon and click Open on the menu that appears. [. . . ]