User manual ESCALADE SPORTS 2L-4105-00

[. . . ] DO NOT HIT CASTER SOCKET TOO HARD WITH A HAMMER!Insert casters #11 into caster sockets #12. Connect the two Name Plate Assemblies to the Cross Support #28, as shown in Figure 1, using four bolts #31 and four nuts #15. Install a safety latch #8 into the right-hand hole on each name panel as shown in Figure 1. [. . . ] If floor is not carpeted, brace table top half with a heavy object to keep it from sliding. Repeat steps 5 thru 13 on second table half. Figure 3 9. 10. 11. 12. 13. Figure 4 14. 15. Figure 5 AT LEAST TWO (2) ADULTS ARE NEEDED TO COMPLETE THE REST OF THIS ASSEMBLY!WHEN ASSEMBLING TOPS TO BASE, HANDLE TOP ASSEMBLIES BY GRASPING ONLY THE TOPS THEMSELVES. DO NOT GRASP METAL LEGS, U-SUPPORT, LINKAGE, OR HINGES. THESE PARTS CAN MOVE AND COULD PINCH FINGERS OR HANDS CAUSING SERIOUS INJURY!ASSEMBLE AS SHOWN WITH LEGS FULLY CLOSED AND TOPS IN A VERTICAL POSITION. TABLE TOPS ARE HEAVY - DO NOT ATTEMPT TO ASSEMBLE ALONE!With two adults, attach table top (#1) to table base, as shown in Figure 5. With at least one adult on each side of table top, lift top and align ends of "U"-support tube with top of upright tubes. With two adults, put other table top onto other pivot tubes following instructions in previous step. DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL BOTH TOPS ARE INSTALLED!IT COULD BE KNOCKED OVER CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE. 17. 3 NET ASSEMBLY Net System Description 1. Net Post Assembly Attach plastic net post as shown with washer and knob. Note: there is a left and right net post assembly (See Net System Description). Post assembly should rest flat against nut plate. Slide the net sleeve over the vertical post while the net post assembly is folded in toward the side of the table top. Fold the net post assembly out against the net post stop into the post and secure bead chain in catch. 2. Adjustments A - Adjust overall net tension by slightly loosening the knob and moving net post assembly. Net post assembly should be kept square with the table by the net post stop (See Net System Description). B - Adjust tension of cord with bead chain on each side. Assure that chain is fully seated in catch. C - Position top of net to a regulation height of 6" from the table surface by firmly gripping the vertical net post within height adjustment slot. 3. [. . . ] IMPORTANT: Periodically, lubricate all moving parts, including pivot points, to assure smooth opening and closing. A light lubricant such as WD-40 is recommended. LIMITED WARRANTY Manufacturer warrants to the original retail purchaser, this product to be free from defects in material and workmanship for a period of ninety (90) days from the date of purchase. Should this product become defective due to material or workmanship within the warranty period, contact our Customer Service Department for repair or replacement at our option. This warranty is not transferable and does not cover normal wear and tear, bowing of the table or damage caused by improper handling, installation or use of this product. [. . . ]