User manual ESCALADE SPORTS 2L-6627-00

[. . . ] Wear a mouthguard when playing to avoid dental injuries. When adjusting height, keep hands and fingers away from moving parts. During play, do not wear jewelry (rings, watches, necklaces, etc. ). Objects may entangle in net. Model PRO BASKETBALL SYSTEM B2309 Thank you for purchasing our basketball system. [. . . ] Clean off any concrete that may be on exposed threads. Note: The bottom four nuts will be forever embedded in concrete. Figure 2 4 Let concrete stand for a MINIMUM of 72 hours. GOALRILLATM I ASSEMBLY INSTRUCTIONS (Day 5) NOTE: It is important for the installer to understand the necessity of the nylon washers (#5) provided. These washers adequately space painted parts at all pivot points. Neglecting the use of these washers will result in rusted parts. NOTE: All board arms are made of rectangular tubing. Tightening hardware too tight may damage tubing and make adjustment of system difficult. Slide Actuator Sleeve (#15) over Actuator (#16) and place Actuator Cap (#13) on top. Slide Pivot Tube (#14) in hole near the top of Actuator until equal amounts stick out on both sides of Actuator. NOTE: It may be necessary to use a hammer or rubber mallet to tap in Spacer. Figure 3 2. Figure 4 3. Lay Pole (#2) on its side on two padded saw horses. Attach Actuator (#16) to Pole (#2) using one bolt (#19), split lockwasher (#18), washer (#3) and two plastic washers (#5) to thread into each side of Actuator. Insert Pole Cap (#1) into top of Pole (#2). It may be necessary to use a hammer or rubber mallet to tap Cap in. 4. Attach lower arm (#11) to Pole (#2), as shown in Figure 4, using a bolt (#8), two flatwashers (#3), four plastic washers (#5) and hex nut (#4). Note: make sure "Goalrilla lettering is right side up. Secure Actuator (#16) to Lower Arm (#11) using one bolt (#8), two flatwashers (#3), four plastic washers (#5) and one hex nut (#4). Tighten both bolts (#8) securing Lower Arm (#11). Tighten bolts snug but, do not over tighten. If the four Tube Plugs (#10) are not already installed insert them into open ends of Lower Arm (#11). It may be necessary to use a hammer or rubber mallet to tap plug in. 5 5. Figure 5 6. 7. Attach Upper Arm (#6) to Pole (#2), as shown in Figure 6, using a bolt (#7), two flatwashers (#3), four plastic washers (#5) and hex nut (#4). Tighten bolts snug but, do not over tighten. If the four Tube Plugs (#10) are not already installed insert them into open ends of Upper Arm (#6). It may be necessary to use a hammer or rubber mallet to tap plug in. 8. PLACING THE POST ON THE ANCHOR SYSTEM REQUIRES AT LEAST FOUR CAPABLE ADULTS. POLE WILL WANT TO LEAN WHILE ATTEMPTING TO STAND IT UP ON ANCHOR BOLTS. Figure 6 9. Locate hardware needed to mount pole to anchor bolts. [. . . ] Shipping charges for replaced or warranted merchandise being sent back to the customer from our factory must be prepaid by the customer in advance. If not, the replacement shipment will be sent out collect. Escalade Sports reserves the right to examine photographs or physical evidence of merchandise claimed to be defective, and to recover said merchandise, prior to authorization of warranty claims. A "Returned Goods Authorization" number may be required, please call for details prior to the return of any photographs or merchandise. [. . . ]