User manual ESCALADE SPORTS 2L-6804-00

[. . . ] CHECK INSIDE ALL PARTS AND CARTONS BEFORE ASSEMBLING OR ORDERING PARTS. USE THE HARDWARE IDENTIFIER TO IDENTIFY AND SORT ALL FASTENERS. ALL HARDWARE IS NOT LOCATED IN ONE KIT. PLEASE DO NOT RETURN PRODUCT TO THE STORE! Contact Escalade® Sports customer service department at: Phone: 1-866-556-2757 Toll Free !E-mail: pooltables@escaladesports. com Mailing Address: Escalade® Sports, PO Box 889, Evansville, IN 47706 Please visit our World Wide Web site at: www. escaladesports. com On-Line Trouble Shooting Frequently Asked Questions Technical Assistance On-Line Parts Requests ® Additional Escalade Sports Product Information 2L-6804-00 Escalade® Sports products may be manufactured and/or licensed under the following patents. [. . . ] Push a bolt #40 with washer #50 through side holes in beam through leg assembly and secure with a washer #50 and hex nut #49. Repeat steps 1-4 for all four leg assemblies. Go back and tighten all hardware at this time. WARNING THIS STEP REQUIRES AT LEAST THREE ADULTS. DO NOT REST WEIGHT OF TABLE ON APRONS OR ON LEGS AT AN ANGLE. 7. Do NOT allow weight of table to set on aprons or on legs at an angle. Lift table flip over and set flat back down on all four legs. Using a carpenter's level, level table as well as possible. Determine the highest corner of the frame. Raise other three corners to the level of the highest corner by shimming underneath legs using playing card stock or grey chipboard stock (#47) shipped with this table. Cut this chipboard and place under 2 X 6 wooden leg posts (#20). Figure 1 Detail A INDIVIDUAL LOCATION SHIMMING Individual location shimming can be done, IF NECESSARY, by following the following steps. A) Be sure table is set in its final location. B) Table must be as level as possible before shimming. Large differences in levelness must be corrected by raising or lowering frame with shim stock. C) Check with a carpenter's level to determine where bed is low. Loosen screws from underneath, at these points and see if slatron comes up to flat. If so, detach individual shims #38 from the sheet shipped with this table and place under these areas. D) Lay a straight edge across bed to be sure it pieces is flat. Page 3 ONE YEAR LIMITED WARRANTY This consumer warranty extends to the original consumer purchase of any ESCALADE® SPORTS Product (hereinafter referred as the "Product"). WARRANTY DURATION: This Product is warranted to the original consumer purchase of a period of one (1) year from the original purchase. [. . . ] This warranty is also void if product is in any way abused, damaged, or modified from its original state, or if used for other than indoor residential use. This warranty gives the consumer specific legal rights, and may have other rights which may vary from state to state. WARRANTY DISCLAIMERS: ANY IMPLIED WARRANTIES ARISING OUT OF THIS SALE, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE ABOVE WARRANTY PERIOD. ESCALADE® SPORTS SHALL NOT BE LIABLE FOR LOSS OF USE OF THE PRODUCT OR OTHER CONSEQUENTIAL OR INCIDENTAL COSTS, EXPENSES OR DAMAGES INCURRED BY THE CONSUMER OF ANY OTHER USE. [. . . ]