User manual ESCALADE SPORTS 2L-6820-00

[. . . ] Tools required for assembly: Phillips screwdriver, tape measure, two 7/16" wrenches and two 9/16" wrenches (adjustable wrenchs may be substituted for the wrenches). Please Do Not Return This Product To The Store! Contact Escalade® Sports customer service department at: Phone: 1-866-873-3528 Toll ­ Free !E-mail: tabletennis@escaladesports. com Mailing Address (correspondence only): Escalade Sports PO Box 889 Evansville, IN 47706 Please visit our World Wide Web site at: www. escaladesports. com ON-LINE TROUBLE SHOOTING ON-LINE PARTS REQUESTS TECHNICAL ASSISTANCE FREQUENTLY ASKED QUESTIONS ADDITIONAL ESCALADE® SPORTS PRODUCT INFORMATION 2L-6820-00 Escalade® Sports products may be manufactured and/or licensed under the following patents. 6120397, 5816957, 5769744, 5119741, 4911085, 4717157, D460140, D420563 Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product. 1. [. . . ] NOTE: Casters should always be locked unless moving table. 5 5. SETTING TABLE UPRIGHT CAUTION At least two adults are needed to complete the following steps. Be sure top halves are locked in safety latches!Be sure that both locking casters are locked!You must use a 7" stack of magazines (or similar block) to protect the casters when lifting table upright! 16. Before lifting table, be sure both top halves are locked in safety latches!Put a 7 inch stack of magazines, wood, etc. under caster beam nearest the floor to protect casters. With the help of one other adult, brace lower caster beam with your foot and lift table upright. Once upright, release safety latch and lower table top halves. (See Detail M and OPERATING INSTRUCTIONS on next page). MAKING FINAL ADJUSTMENTS If your gap between table halves is greater than 5/16" or uneven adjust it as follows. Loosen the six bolts shown below and adjust table so that the space between the two table top halves measures 5/16 of an inch. Check over entire assembly to be sure all nuts and bolts are secure. Remember, do not overtighten bolts at joints that move. 6 OPERATING INSTRUCTIONS CAUTION !ALWAYS LOCK TABLE TOP HALVES IN SAFETY LATCHES WHEN STORING, MOVING, OR USING TABLE IN ITS PLAYBACK POSITION!!ALWAYS LOCK CASTERS, EXCEPT WHEN MOVING TABLE!!DO NOT SIT, STAND, WALK OR JUMP ON THIS TABLE! To open table: 1. Release safety latch and pull table top outward and downward. Be ready to support weight of table top. Check that top is locked in safety latches. Net System Description 1. Net Post Assembly Attach plastic net post as shown with washer and knob. Note: there is a left and right net post assembly (See Net System Description). [. . . ] Set the table in its PLAYING POSITION and move table several inches in different directions to find the best location for the table. If the floor is extremely unlevel, table may not play or operate properly. If table is high in the center, shim up under the outer U-legs. ONE YEAR LIMITED WARRANTY This consumer warranty extends to the original consumer purchase of any ESCALADE® SPORTS Product (hereinafter referred as the "Product"). WARRANTY DURATION: This Product is warranted to the original consumer purchase of a period of one (1) year from the original purchase. [. . . ]