User manual ESCALADE SPORTS 2L-6859-00

[. . . ] LEATHER DROP POCKET POOL TABLE MODEL NO. READ THIS MANUAL CAREFULLY BEFORE STARTING ASSEMBLY. Read each step completely before beginning each step. SOME SMALLER PARTS MAY BE SHIPPED INSIDE LARGER PARTS. CHECK INSIDE ALL PARTS AND CARTONS BEFORE ASSEMBLING OR ORDERING PARTS. [. . . ] Sections should be Any dirt and debris can cause table top sections to even. You should not need shims to even up the table top sections 22. Place center section #7 back on slats and secure it to long #6 and #7, so if the sections do not align, first try loosening slats #22 with six screws #8. Dry soap on screw threads screws and brush out underneath to remove chips etc. . CAUTION: When driving screws Then check under table to make sure there are no gaps through slatron sections, hold slatron down tight against between the table top sections and the slats. If gaps exist, the slats so they don't ride up on the screws. However, do not tighten screws so sure there are no gaps between center section #7 much that the sections begin to crush or crack. of seams must be precisely level and even with one However do not tighten screws so much that another. If you need to use shims, read the shimming center section begins to crush or crack. instructions on the following page. Page 7 SHIMMING INSTRUCTIONS General Rules !Accomplish the leveling of slate/slatron with as few shims as possible. Do not tap with a hammer or tighten screws unreasonable tight. You will not be able to compress the slate/ slatron. You must shim up the slate/slatron to level. Shims #38 are meant only to raise the low places at the seams and ends. Very short and low places should be grouted. Most leveling can be accomplished by working with the frame. If power tools are used, be sure only enough torque is used to do the job. Seams can best be checked by passing your finger over the seam joint and feeling if it is flush. All screws must be tightened after shimming. No two sets of slate/slatron are exactly alike. Some sets require more, or less, shimming than others. Figure 12 26. [. . . ] Secure rails in position to the playing surface using studs #13, dome washers #11, lock washer #12 and hex nuts #46 in the center holes of each rail. On the outside holes next to each pocket use studs #14, dome washers #11, lock washer #12, pocket blocks (corner pocket blocks #9, side pocket blocks #10) and hex nuts #46. Attach pocket nets to bottom of pocket blocks #9 and 10 using one screw #15 for each mounting tab. A day later the table may have settled so check the levelness of the table the same way you did in step 17. [. . . ]