User manual ESCALADE SPORTS 2L-6900-00

[. . . ] B2 214 Goaliath 48 BASKETBALL SYSTEM MODEL NO. OWNER'S MANUAL 1. Read this manual carefully before starting assembly. Read each step completely before beginning each step. Some smaller parts may be shipped inside larger parts. [. . . ] NOTE: If necessary, use a hammer or rubber mallet to tap in Pivot Tube (#14). Slide tab on Actuator (#16) between Post Ears (#30 and #31) and secure using one bolt (#19), two washers (#20) and one lock nut (#4). Insert Pole Cap (#1) onto top of Pole (#2). Secure two stop spacers (#10) to pole, as shown in Figure 4, using one hex bolt (#22) and one lock nut (#4). 6. 7. 4 Figure 5 8. Attach lower arms (#11) to Pole (#2), as shown in Figure 5, using a hex bolt (#22), two flatwashers (#18), two plastic washers (#5) and lock nut (#4). Note: make sure lettering is right side up. Do NOT tighten bolt (#22) at this time. Secure Actuator (#16) to Lower Arms (#11) using one bolt (#22), two flatwashers (#18), two plastic washers (#5) and one lock nut (#4). Tighten both bolts (#22) securing Lower Arm (#11). Note: Tighten bolts snug but, do not over tighten. Insert four Tube Plugs (#9) into open ends of Lower Arms (#11). It may be necessary to use a hammer or rubber mallet to tap them in. Note: Tube Plugs (#9) may already be installed in the board arms. 9. Figure 6 11. Attach long leg of Upper Arms (#6) to Top Pole (#3), as shown in Figure 7, using a bolt (#7), two flatwashers (#18), two spacers (#8) and one lock nut (#4). Note: Tighten bolts snug but, do not over tighten. Insert four Tube Plugs (#9) into open ends of Upper Arms (#6). It may be necessary to use a hammer or rubber mallet to tap plug in. Note: Tube Plugs (#9) may already be installed in the board arms. 5 Figure 7 PLACING THE POST ON THE ANCHOR SYSTEM REQUIRES AT LEAST FOUR CAPABLE ADULTS. POLE WILL WANT TO LEAN WHILE ATTEMPTING TO STAND IT UP ON ANCHOR BOLTS. 13. Locate hardware needed to mount pole to anchor bolts. You will need, eight flatwashers (#37), four lock washers (#36), four hex nuts (#35) and four thread protectors (#34). Put a flat washer (#37) on each anchor bolt. Lift post onto anchor system and secure with one flatwasher (#37), one lock washer (#36) and one hex nut (#35) for each anchor bolt. [. . . ] Subject to proper installation and normal use, Escalade® Sports warrants, subject to the limitations below, to the original retail purchaser all structural components of the Goaliath® System to be free of defects in material and workmanship for a period of five (5) years from the original purchase. Merchandise must be shipped prepaid with a copy of proof of purchase to Escalade® Sports factory for examination to determine if the basketball system needs to be repaired or replaced. Torn back plates, damaged springs, bent rings, damaged eyebolts, and torn or distorted rim supports result from hanging on the rim and are not warranted. Note: Any merchandise shipped to Escalade® Sports collect will be refused. Dealer service charges, labor charges and travel expenses associated with replacement of repair of warranty item. WARRANTY DISCLAIMERS: ANY IMPLIED WARRANTIES ARISING OUT OF THIS SALE, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION. [. . . ]