User manual ESCALADE SPORTS 2L-6991-00

[. . . ] 2) Please read this instruction manual completely before starting assembly. 3) DO NOT allow any use of the equipment until it been completely assembled and installed in accordance with these instructions. 4) Please keep a copy of your order and our catalog with this manual for future reference in ordering replacement parts. [. . . ] Please read this step in its entirety and ensure you know what you are going to be doing before you proceed. 4-3/4 x 5/16 Carriage Bolts If you have a Glacier play system or if you are installing on the Long Side of the 6x3 Tower on an Everest play system, go to Paragraph A below. If you are installing either Short Side of the 6x3 Tower on an Everest play system, go to Paragraph B below. Observe the Universal Mount in the opening to which you are fastening the slide. Observe the narrow edge of the Mounting Balusters and note the hole in each about 16 up from the bottom. You will use these holes to fasten the top of the Slide. Lift the end of the Slide up and place it into position in the opening between the Balusters. Bolt the top of the Slide to the Mounting Balusters with two 4-3/4 x 5/16 Carriage Bolts and 5/16 Safety Nuts. The bolts pass first through the plastic of the Slide bedway, the green Slide Rail, the Mounting Baluster, and finally the Safety Nut. The Safety Nuts must not be on the inside of the Slide. Skip to Step 4. 4 (View of a Short Side of an Everest play system) Mounting Balusters 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 4321 Illustration 4 B) See Illustration 4. Observe the Balcony Side Mount in the opening to which you are fastening the Slide. Observe the narrow edge of the Mounting Balusters and note the hole in each about 16 up from the bottom. You will use these holes to fasten the top of the Slide. Lift the end of the Slide up and place it into position in the opening between the Balusters. Bolt the top of the Slide to the Mounting Balusters with two 4-3/4 x 5/16 Carriage Bolts and 5/16 Safety Nuts. The bolts pass first through the plastic of the Slide bedway, the green Slide Rail, the Mounting Baluster, and finally the Safety Nut. The Safety Nuts must not be on the inside of the Slide. Now go to Step 4. 4-3/4 x 5/16 Carriage Bolts 5 Illustration 5 Step 4. [. . . ] Nail each Stake to the Base using the nails provided. Use the pre-drilled holes and three nails for each Stake. ASSEMBLE AND INSTALL ALL REQUIRED DECK-LEVEL ADD-ONS Return to your Everest or Glacier play system manual and complete the installation of all required Deck-level Add-ons. [. . . ]