User manual ESCALADE SPORTS 2L-7029-00

[. . . ] Tools required for assembly: Phillips Screwdriver, Two 7/16 Wrenches, One 3/8 Wrench (an adjustable wrench may be substituted for the wrenches). Please Do Not Return This Product To The Store! Contact Escalade® Sports customer service department at: Phone: 1-866-873-3528 Toll Free !E-mail: tabletennis@escaladesports. com Mailing Address (correspondence only): Escalade Sports PO Box 889 Evansville, IN 47706 Please visit our World Wide Web site at: www. escaladesports. com ON-LINE TROUBLE SHOOTING ON-LINE PARTS REQUESTS TECHNICAL ASSISTANCE FREQUENTLY ASKED QUESTIONS ADDITIONAL ESCALADE® SPORTS PRODUCT INFORMATION 2L-7029-00 Escalade® Sports products may be manufactured and/or licensed under the following patents. 6120397, 5816957, 5769744, 5119741, 4911085, 4717157, D460140, D420563 Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product. Ó2005 Escalade ÒSports 1. [. . . ] Secure through end hole with screws #23, locknuts #15 and plastic spacers #31. Tighten hardware snug enough to keep table stable but do not overtighten. On one side of the table attach slotted end of safety strap #6 to INSIDE of U-Leg #2 using one bolt #29, one spacer #30, one washer #24, and one hex nut #15. Tighten hardware until snug but do not overtighten. Attach other end of safety strap #6 to OUTSIDE of linkage #4 using one bolt #9, one washer #24, one spacer #30, and one hex nut #15. Do NOT put other safety strap #6 on this table half. It will be installed on other table half later. Attach other end of linkages #4 to OUTSIDE of U-support #7 with screws #14 and plastic washers #24. Tighten hardware until snug but do not overtighten. Tubes must pivot freely. CAUTION: AT LEAST TWO ADULTS ARE NEEDED TO MOVE TABLE HALF! 19. Prepare an area for the assembly of the second table top half. If necessary, move the first table top half aside with the aid of a helper. Be sure to place it in a location where it won't be disturbed or damaged. If setting on its side, be sure to place the bottom edge no less than 12 inches away from the wall. Also be sure to place carpet or pieces of the shipping carton down to protect table top edges. If floor is not carpeted, brace table top half with a heavy object to keep it from sliding. 14 4 31 15 15 4 24 7 2 Second Table Half 2 30 9 24 6 30 15 29 15 24 Figure 9 5 20. Repeat steps 6 through 18 on second table half. AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE REST OF THIS ASSEMBLY!WHEN ASSEMBLING TOPS TO BASE, HANDLE TOP ASSEMBLIES BY GRASPING ONLY THE TOPS THEMSELVES. DO NOT GRASP METAL LEGS, USUPPORT, LINKAGE, OR HINGES. THESE PARTS CAN MOVE AND COULD PINCH FINGERS OR HANDS CAUSING SERIOUS INJURY!ASSEMBLE AS SHOWN WITH LEGS FULLY CLOSED AND TOPS IN A VERTICAL POSITION. TABLE TOPS ARE HEAVY - DO NOT ATTEMPT TO ASSEMBLE ALONE! 21. [. . . ] STORAGE OF YOUR TABLE This table must be stored indoors to prevent damage to the playing surface. Dampness and extreme temperature changes can cause the wood to warp, swell, crack or blister. When your table is not in use, it should be folded up in a dry area. Due to the nature of particle board, table top may bow. [. . . ]