User manual ETON S800

[. . . ] FRONT PANEL DESCRIPTION (See page 12) LCD DISPLAY DESCRIPTION (See page 14) REAR PANEL DESCRIPTION (See Paee 15) 3 SPECIFICATIONS Frequency Range: 100 to 30. 000 kHz (0. 1 to 30 MHz). FM mode only for 87 to 108 MHz. Line Audio Outputs: Stereo left and right. supplied from AC ADAPTER, external DC Power Supply or 5. 7 to 9. 0 VDC supplied by (6) internally mounted "D" cell (1. 5V) batteries (not supplied). Headphone Jack: DC Power Requirements: Sensitivity - SSB (10 dB S+N/N): Sensitivity - AM (10 dB S+N/N): (1000 Hz. 30% Mod): Sensitivity - FM (20 dB S/N) (monaural): Frequency Stability Frequency Accuracy: Selectivity - SSB. [. . . ] Extend the telescoping sections and position the antenna for best signal reception. Be sure the corresponding rear panel antenna select switch is set to the 'WHIP' position for WHIP antenna reception. 15 GETTING STARTED GENERAL OPERATING INFORMATION The SATELLIT 800 MILLENNIUM receiver has been designed for ease of use. Please take a few moments to read through this section and familiarize yourself with general operating information. MICROPROCESSOR RESET A power-up reset routine will be activated anytime after the receiver COMPLETELY loses power, either from internal batteries or external DC input. This will be observed by the front panel display illuminating all annunciators for 3 seconds, followed by the clock display. However, short term power failures of up to 30 minutes are masked by an internal back-up capacitor. This will allow ample time for battery replacement without loss of the internal clock. Note: Any programmed memory locations will NOT be lost under a power-up reset due to the memory design of the SATELLIT 800 MILLENNIUM. BEEP TONES The SATELLIT 800 MILLENNIUM responds to all key depressions with an audible beep unless the beep has been disabled by the BEEP button. No beep is generated under any condition for depressions of the TUNING keys when in VFO mode. Beep tones indicate the following: One short tone for a key depression. One long, high tone when storing a memory channel. One long, low tone for any illegal key depression. FIRST STEPS Please refer to the front panel illustration and set the controls as described below. (1) Install 6 "D" batteries or connect AC ADAPTER. (2) Fully extend the whip antenna and adjust to a vertical position, or connect an external antenna to appropriate rear panel terminals. Set rear panel 'ANTENNA SELECT' switch(es) to appropriate position(s). (3) Press 'POWER' and adjust 'VOLUME' to a comfortable level. (4) Select the desired band by pressing the 'BAND' button until the desired band is displayed on the front panel display. (5) Enter the desired frequency by using one of several methods covered below. DIRECT FREQUENCY ENTRY Direct entry of a desired frequency is possible using the 'Direct-Key-Input' keys. While entering a frequency, if an incorrect frequency is entered, pressing the ' ' button will clear the entry in progress and return the receiver to its previous settings. [. . . ] Timer does not operate. (A) Lock enabled. (A) Press and hold for 3 seconds to unlock front panel. (B) Set clock(s) and program timer ON/OFF times. (C) Check that last displayed clock is the desired one for timer event. SUGGESTED REFERENCES (1) Passport to World Band Radio Published by: International Broadcasting Services, Ltd. Box 300 Penn's Park, Pennsylvania 18943 (2) World Radio TV Handbook Billboard Publications Inc. [. . . ]