User manual EURO-PRO 7500

[. . . ] When using an electrical appliance, basic safety precautions should always be followed, including the following: Read all instructions before using this sewing machine. An appliance should never be left unattended when plugged in. Always unplug this appliance from the electric outlet immediately after using and before cleaning. Close attention is necessary when this appliance is used by or near children. [. . . ] Release lever and the machine will sew forwards again (A/1). Stop the machine at the point where you wish to change directions with the needle still in the fabric. Raise the presser foot and turn the fabric to line up its new direction using the needle as a turning point. Lower the presser foot and start sewing in the new direction. Turn the handwheel towards you to bring the thread take up lever to its highest position. Raise the presser foot and draw the fabric away from you. Hold the threads behind the presser foot with both hands, guide them to the slit (B) and press down. Heavy woollens, overcoat fabrics, upholstery fabrics, some leathers and vinyls. Most threads sold are medium size and suitable for these fabrics and needle sizes. IMPORTANT: Match needle size to thread size and weight of fabric NEEDLE, FABRIC SELECTION NEEDLES HA×1 15×1 15×1/705H (SUK) 15×1/705HS (SUK) 130 PCL EXPLANATION Standard sharp needles. Can be used instead of 15 1 for sewing all fabrics. (Leaves smaller hole than standard large needle. When sewing with twin needles, the stitch width dial should be set at less than "3". American and Japanese needles show size 9, 11, 12 etc. Replace needle often (approximately every other garment ) and / or at first thread breakage or skipped stitches. How to choose your pattern 2 1 3 For straight stitch select pattern "A" with pattern selector dial (5). adjust the stitch length with the stitch length dial (2). You may choose any needle position, by turning the stitch width dial (2). for zigzag stitch , select pattern "B" with pattern selector dial (5). Adjust the stitch length (3) and stitch width (2) according to the fabric being used. To obtain any of the other patterns shown in the upper row on the stitch selection panel, select the letter above the stitch with the pattern selector dial. Adjust the stitch length and the stitch width with the control dials according to the result desired. [. . . ] This machine automatically produces a scallop stitch which may be used as decorative edging. (1) - If desired, trim around the scallop with scissors to create a scalloped edge. These stitches are used to join two pieces of fabric while leaving a space between their edges. Fold over the edges of the two pieces of fabric for the hem and baste the edges to a thin piece of paper leaving a small space between them. [. . . ]