User manual EVENT TR

[. . . ] If you need to return the speakers to the factory for repair, they must be shipped in the original packaging. TUNED REFERENCE USER GUIDE Setup 3 You'll notice that the Tuned Reference monitors are physically identical. When used in a stereo configuration, there is no physical or acoustic distinction between the left and right speakers. Note, too, that the cabinets can sit vertically or horizontally without regard for performance, so long as both cabinets are situated in the same direction. [. . . ] Balanced XLR Line Input This jack accepts a male XLR connector, wired for either balanced or unbalanced operation. For balanced operation, please consult the pin wiring diagram on Page 5 or on the monitor's back panel. The Line 1 input is hardwired in parallel with the Line 2 input, so either may be used as an input or as a pass-through connection. Input specifications apply to both inputs equally. Balanced 1/4" Line Input This jack accepts a male two-conductor 1/4" TS or three-conductor 1/4" TRS connector, wired for either balanced or unbalanced operation. For unbalanced operation with a TS connector, the minus signal is automatically grounded; with a TRS connector you have the option of leaving the minus input open or grounded. We recommend, however, that you ground the unused input. For balanced operation, which requires using a TRS connector, please consult the pin wiring diagram on Page 5 or on the monitor's back panel. TUNED REFERENCE USER GUIDE The Line 2 input connector is hardwired in parallel with the Line 1 input connector, so either may be used as an input or as a pass-through connection. Input specifications apply equally to both inputs. 5 INPUT SENSITIVITY -5dB INPUT CONNECTIONS BAL BAL UNBAL SIGNAL XLR 1/4" 1/4"­ RCA + PIN 2 TIP TIP ­ PIN 3 RING SHIELD PIN 1 SLEEVE SLEEVE -20dB MAX BALANCED INPUTS UNBAL INPUT POWER REQUIREMENTS 120V~ 60HZ 0. 8A 100W 220/240V~ 50/60HZ 0. 5A 100W 100V~ 50/60HZ 1. 0A 100W Figure 2. Tuned Reference rear panel connections and controls. Unbalanced RCA Line Input This jack accepts a male RCA connector, wired for unbalanced operation. This jack is hardwired in parallel with the balanced line inputs. However, due to it being an unbalanced input, we do not recommended using it in combination with either of the balanced inputs, as this will unbalance those inputs, possibly causing degradation of the audio signal. 6 TUNED REFERENCE USER GUIDE Input Sensitivity This control is used to compensate for different signal levels that appear at the input. The control has a 20dB range; when set at maximum (MAX), 0. 5V RMS input at the balanced ins or 0. 25V RMS at the unbalanced in will produce full amplifier output. Note that when the signal appearing at the input is too hot, the amplifiers may overload, causing distortion. If this occurs, attenuate (decrease) the Input Sensitivity by turning the control counter-clockwise. Power Switch Push to turn the amplifiers ON; push again to turn them OFF. When the amplifiers are ON, the green LED located in the metal trim ring on the front of the monitor will illuminate. Power Connector This connector accepts the detachable AC line cord. [. . . ] If you believe your Tuned Reference monitor is in need of repair, please contact the Event Electronics Customer Ser vice department to request a Return Authorization Number (RA#). We can accept for ser vicing only those units that are accompanied by an RA#. Units shipped without an RA# number will be refused. Tuned Reference Specifications Low Frequency Driver TR5: 5. 25"; TR6: 6. 5"; TR8/8XL: 8" magnetically shielded mineral-filled polypropylene cone with high temperature voice coil and damped rubber surround. [. . . ]