User manual FAGOR 3CFT-90VISLA

[. . . ] If the carbon filter is mounted inside the hood, it must be removed and the protective grid mounted in its place. If the plug is not accessible once it has been inserted in the socket, it will however be necessary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm. Appliance without plug Fit an approved plug or an approved bipolar switch with a minimum contact opening of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observer the above instructions. [. . . ] To switch off the system, re-press the same two Buttons: after 3 seconds LED 5 will stop flashing and the device will be switched off. 6 - Intensive speed LED 7 - Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button 1 or button 2. 8 - OFF lamp button 9 - ON lamp button If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. When washed in a dish washer, the grease filter may discolour slightly, but this does not affect its filtering capacity. The metal grease filters must be washed at least once a month and anyhow whenever the LED 4 indicates the saturation of the filter (see page 13). This LED flashes to warn you that the metal grease filters must be cleaned. Generally, these must be cleaned after 40 hours of use. Once the grease filters have been cleaned, press button 1 for about3 seconds until you hear the acoustic signal (beep): the LED 4 will now stop flashing. A - push toward the centre b - pull the filters downwards. Let the filter dry without damaging it before putting it back into place. Carry out the above steps in reverse order to put the filters back after having washed them. Children should not be allowed to tamper with the controls or play with the appliance . -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. [. . . ] Clean also the accessible internal parts after having removed the grease filters, the hood is designed so this can be done easily and safely. Clean the external surface of the cooker hood almost once every 10 days. Attention Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. [. . . ]