User manual FAGOR 5CFB-30X

[. . . ] * The air sucked can't be vented through or into a duct used to let out fumes from appliances fed by energy other than electric power (eg. * To evacuate the air outlet, please comply with the pertaining rules given by competent authorities. * Flambe cooking is prohibited underneath the range hood. *Ensure the room has adequate aeration when a range hood and appliances fed by energy other than electric power (gas-, oil-, or coal- stoves, etc. [. . . ] 1), the air and fumes vented by the appliance are depured both by a grease filter and by an active coal filter, and put again into circulation through the side-grids of the chimney. For this version an air deflector placed on the superior part of the pipe and allowing airrecycling is necessary (Fig. 2), fumes are directly vented outside, through an evacuation duct connected with the superior part of the wall or the ceiling. Both coal filter and air deflector are not necessary in this case. * Before installing the appliance and in order not to damage the appliance itself, the metal grease filter should be removed. Such filter can be removed by pushing the special filter handle toward the back side of the range hood and turning it downwards so as to unfasten it from its slot (Fig. Wall stirrup-fixing * Using the special drilling jig (Fig. 4X), perforate the wall according to the pattern indicated by the jig itself, and pay attention in order not to damage water pipes and electric wires. Perforation should be performed with a Ø 8 mm walldrill. Then insert the proper plastic reinforcements (Fig. 4S) can be applied by using the screws provided with the equipment (Fig. Now hook the range hood onto its bearing (Fig. 5) and then adjust horizontally and vertically the position of the appliance by adjusting the special metric screws (Fig. After the appliance is adjusted, fix it by inserting and tightening the safety screws properly (Fig. Fixing the ornamental chimney * Before fixing the chimney, place the electric feeding equipment into the ornamental pipe and provide a hole for the air outlet if the appliance is used in its sucking version. Before connecting the flexible exhausting pipe to the motor, make sure the stop valve, which is on the air outlet of the motor, can swing. sucking version * Fix the pipe-bearing stirrup (Fig. 7Y) to the wall or ceiling by using the proper reinforcements and screws in equipment. Connect the range hood flange with the evacuation hole by using a proper pipe. 8Y) by using the two self-threading screws. [. . . ] Once the burnt out bulb is located, turn it counter-clockwise and replace it with a bulb of the same type. 13B) - when performing this operation hold the opaque glass carefully. 13C) without touching it with uncovered hands. 10) A: Light switch on/off B: Motor switch on/off (1st rate level) nd C: 2 rate level switch rd D: 3 rate level switch th E: 4 rate level switch F: 10-minute timer. [. . . ]