User manual FAGOR 7CFV-92X

[. . . ] They have been drafted for your safety and that of others. The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into account. The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other than electricity (central heating systems, thermosiphons, water-heaters, etc. [. . . ] Any room where a cooker hood is used at the same time as appliances using gas or any other fuel must be properly ventilated. Avoid using materials which could cause spurts of flame (flambées) near the appliance. When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous in this respect. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. The unit can be found in filtering hoods or in exhaust hoods. 1) the air and steam taken up by the unit are purified with charcoal filters and returned to the environment through the aeration grids on the side of the flue. WARNING: When using filtering hoods, both charcoal filters and an air deflector must be used. Therefore they do not require charcoal filters. To facilitate installation, before starting remove the grease filters: press inward on the clamp at the handle and pull the filter downward (Fig. As previously specified in the chapter "Warning" remember there must be a minimum of 650 mm between the bottom edge of the hood and the stop of the stove. Secure the metal bracket (B) to the wall using the screws and plugs (bracket, screws and plugs are all supplied with the unit). Use the 2 triangles cut into the bracket to position it precisely along the vertical axis of the hood. Adjust the horizontal position, shifting the hood to the right or left as needed lining it up with the wall units. If the height of the hood also requires adjustment, use the special regulation screws (V) (supplied). Once regulation has been completed, finish securing the hood with 2 more screws (M): mark the points for the 2 holes on the wall, remove the hood and drill (8mm diameter holes); then use the plugs and screws to complete installation. Rest the lower edge of the panel behind the stove and anchor the upper edge to the wall using the two holes found on the panel. insert the screws and plugs provided (A). The unit is secured to the rear panel as though it were being installed on the wall: use the supplied metal bracket (B) and the screws and plugs supplied with the panel. Securing the extension flues: Basic installation requirements: ­ Set the electrical power supply within the space covered by the decorative flues. ­ If your unit is installed in an Exhaust hood, prepare the air exhaust hole. When installing exhaust hoods, to achieve the best possible conditions use an air exhaust pipe that : is as short as possible, has a minimum of curves (maximum angle: 90°), is made of a material that complies with the standards (which vary from nation to nation) and iv) is smooth on the inside. [. . . ] Pay special attention to the grease filters: the grease filters must be replaced periodically: exactly how often depends on use (at least once every other month). To remove the filter: push inward on the clamp at the handle and pull the filter downward (Fig. Wash out the filter using a neutral soap. Replacing the charcoal filter: If the unit is a filtering hood, the charcoal filter must be replaced: to remove them press inward on the clamp (Fig. [. . . ]