User manual FAGOR B-625MA

[. . . ] In this manual we have provided a number of safety warnings as well as numerous tips and hints for using the unit. Warnings and tips are marked with the following symbols: Safety warning Tips and hints 3 1 IMPORTANT SAFETY INSTRUCTIONS 1 - Proper Installation - Be sure your appliance is properly grounded and installed by a qualified technician. 2 - Never Use your Appliance for Warming or Heating the Room. 3 - Do Not Leave Children Alone - Children should not be left alone or unattended in an area where the appliance is in use. [. . . ] This device will not allow the heating element to turn on unless it senses cookware on the burner covering enough surface area. The indication that the burner is not running is the flashing of the digital display. Once the pan is put properly on the burner, the digital display will become steady. Note that a small object such as a fork, a spoon, a piece of jewelry, etc. will not be mistaken for cookware, and it will not trigger this sensor. Moreover, this device will distinguish between cookwares which are and are not suitable for induction cooking. If cookware which is not suitable for induction cooking is placed on a burner there will be no power output on the burner. · If an operator leans on the keypad by chance for more then ten seconds, controls will disable the heating section of the unit. This occurrence is called `long press' and when it happens "-" signs will appear on power displays. The unit will act the same if there is an accumulation of some liquid on the keypad area, or if a damp cloth is left sitting on the keypad. The section will become operational again once the spill or the object/hand is removed, and the element turned back on. To perform a cookware test: - Turn an element on and adjust power to any level. You will notice that the digital power display is flashing. If the piece being tested is suitable for induction cooking, the display will become steady. However, if it keeps flashing, the cookware cannot be used on your induction unit. - If the cookware is empty, remove it from the burner immediately after you have done the test and turn the element OFF. Another simple test to determine if a piece of cookware can be used on an induction cooktop is the `magnet test'. Use a magnet and place it on the cookware. If the magnet sticks to it, the piece will work with induction. Cookware compatible with induction units are: · Cookware made of enamel coated steel with or without a non-stick coating. · Cast iron cookware with or without enamel coated base. · Stainless steel pots and pans designed for induction cookware. [. . . ] There is an internal problem with the unit. The electronic components are under power and they create heat. The noise occurs when the power is being shared between two induction burners. There may be a power supply or internal problem. [. . . ]