User manual FAGOR CC-70D

[. . . ] Do not use it to defrost pipes or prevent them from freezing; do not hang clothing on it to dry. Do not cover it with clothing or put flammable objects on top of it such as cushions, newspapers or curtains. Do not plug the heater into loose or worn sockets. Do not wash it with water or touch it with wet hands. [. . . ] Any other use not recommended by the manufacturer could cause a fire, electric shock or other physical damage to people. Avoid the use of extension cables because they can overheat the heater and cause a fire. The appliance will not operate if it is not resting appropriately on the ground. IMPORTANT: Never cover the appliance whilst it is working as it could cause dangerous overheating. The appliance has a safety switch located on the base which prevents the appliance from working if it falls accidentally. For the safety switch to operate, the appliance must be resting on a firm and stable surface. IMPORTANT: Do not try to block the safety system in any way. Make sure that the heater is on a horizontal and stable surface before plugging it into the power supply. In order to change mode, press this button again. the screen mode indicator (c) will show which mode has been selected. Every time this button is pressed, the selected speed will vary following the sequence in figure 3. When this button is pressed the selected temperature will appear, which is 23 ºC by default. In order to select a temperature, use buttons and . You can select from 18 ºC to 35 ºC and the frost function following the sequence in figure 4. A few seconds after selecting the temperature, the screen will show the ambient temperature again. The heater will be connected until the desired temperature is reached and then The temperature control can be disabled by pressing the button until the temperature symbol (e) disappears. Button once Frost watch function: After adjusting the frost watch function as explained in the "Temperature function" section, the heater will remain disconnected unless the temperature drops below 4ºC. If this occurs, the frost function will connect the heater cycle automatically to stop ice forming on the appliance. Press the timer button; the time adjustment will then appear on the screen in hours and minutes along with the timer symbol (f). Warning: By default, the time is 0 and if there is no adjustment at that time, the timer symbol (f) will be substituted by the continuous symbol (a) in a few seconds. [. . . ] Use a vacuum cleaner to clean out the dust inside if necessary. WARNING: DO NOT submerge the heater in water or let the inside of the heater get wet, as this could cause an electric shock. Tidy the cable into loops and fix them with tape. At the end of its working life, the product must not be disposed of as urban waste. [. . . ]