User manual FAGOR CNC 8025 TS FEATURES

[. . . ] 0107 in) ERRORS FOUND IN THE PROGRAMMINGMANUAL (REF. When working in diameters, the "I" value in the table is in diameters and the value to be assigned to parameter "I" in the G51 function must always be given in radius. The figure reads M02 ó M30 It should read: M02 or M30 TING MANUAL (REF. 9701) ERRORS FOUND IN THE OPERA Page 46. [. . . ] In the other modes, the programs are entered directly from the front panel of the CNC. This means that the programming can be carried out both at the machine and at a remote location, e. g. In the PLAY BACK mode, the axes are shifted manually (Jog) and the coordinates reached are then entered as the program coordinates. In the TEACH IN mode, a block is written and executed and then entered as part of the program. In the EDITING mode, the complete program is recorded and then executed. 1. 1. EXTERNAL PROGRAMMING If the programming is to be carried out by means of an external peripheral, ISO code must be used. % will initiate the program, followed by the program number (five digits, followed by the characters, RT or LF and the N of the first block). RETURN or LINEFEED must be used after each block prior to the N of the beginning of the following block. To end the program the characters ESCAPE (ESC) or END OF TAPE (EOT) or a series of 20 nul characters (ASCII 00) must be used. 8025/8030 CNC PROGRAMMING MANUAL 1 1. 2. TEXT PROGRAMMING Comments to be displayed on the CRT must be written between parenthesis ( ). The maximum number of characters which can be written in a comment is 43, parenthesis included. The comment must be written at the end of the block, that is: N4 G. . If the first character in parenthesis is an asterisk (* Comment) the comment will blink on the screen. An empty comment ( ) cancels the display of the previous one. 1. 3. DNC CONNECTION Every CNC offers as a standard feature, the possibility of working with DNC (Distributed numerical control), enabling the communication between the CNC and a computer to carry out the following functions: . Program and table transfers between the CNC and a computer . Ability to supervise the status of the advanced DNC systems 2 8025/8030 CNC PROGRAMMING MANUAL 1. 4. THE FAGORDNC COMMUNICATION PROGRAM Commercialized in a 5. 25" or 3. 50" flexible diskette is an application for the connection of FAGOR numerical controls to a PC or COMPATIBLE computer with FAGOR Numerical Controls, using the DNC incorporated in those controls. Several CNC can be connected to the DNC through the RS 232 lines of these computers. The operation mode is interactive, with MENUS which guide the user and simplify the use of this program. The computer is used as a part-programs centralized STORAGE, avoiding the use of awkward puncher tapes. This simplifies the version upgrading, allows to make safety copies, listing and edition of part programs with inclusion of comments . . . The manual of DNC connection and the FAGORDNC communication can be requested at this address. 8025/8030 CNC PROGRAMMING MANUAL 3 2. CREATING A PROGRAM The machining program must be entered in a form acceptable to the CNC. It must include all the geometrical and technological data required for the machine-tool to perform the required functions and movements. A program is built up in the form of a sequence of blocks. Each programming block consists of: N G 4th, 3rd, X, Z F S T M : : : : : : : Block No. [. . . ] > A program has been defined with more than 5 characters. > A block number has more than 4 characters. > Strange characters in memory. 106 ** Inside temperature limit exceeded. 108 ** Error in Z axis leadscrew error compensation parameters. [. . . ]