User manual FAGOR CR-15

[. . . ] The manufacturer shall not be responsible for any damages that may arise from improper or inadequate use, or for repairs conducted by nonqualified personnel. Do not touch the appliance with wet or damp hands or feet. Keep the appliance separate from water or other liquids, to avoid electric shock; do not connect the appliance to the mains if it is on a damp surface. place the appliance on a dry , firm and stable surface. [. . . ] To do so, fill the tank (11) with water and operate the appliance without coffee several times in a row. Fill the tank (11) with fresh clean water until the MAX mark, and replace it in the coffee maker. " position and plug the coffee maker into the mains. The red indicator light (2) will turn on to indicate that the coffee maker is connected. When the green indicator light (3) turns on, the coffee maker has achieved the working temperature and is ready to make coffee. Place one or two cups on the drip tray (6), under the coffee outlets in the filter holder (4). Wait until the coffee has stopped dripping before removing the filter holder (4). ⷠAfter each use, remove the filter holder (4) and - pushing the filter fastener forwards - empty out the used coffee (fig. When you have finished using the coffee maker, press the I/0 switch PREPARING CAPPUCCINO to the 0 position to switch-off the appliance, and unplug the unit from the mains. Place coffee cups upside down on the cup warming plate (1). When the coffee maker is warm, the plate will heat up the cups placed on it. A cappuccino consists of 1/3 espresso coffee, milk and milk froth. ⷠOnce you have setup the coffee maker, make an espresso coffee (see the section on "Preparing an espresso coffee"). ⷠFill a tall stainless steel vessel approximately 1/3 full of cold skimmed milk. The milk must be cold and the vessel must have been refrigerated, therefore it should not be submerged in hot water. ⷠInsert the steamer (7) in the milk that is to be warmed up and turn the function selector dial (10) to the position (fig. This will allow the vapour to mix with the air and create creamy froth. The froth should be thick with compact bubbles to produce good taste and lasting consistency. ⷠOnce you have finished creating froth, turn the function selector dial (10) to the · Pour the frothy milk onto the espresso coffee and fill the cup to the top with the remaining milk. Having setup the coffee maker, when the green indicator light turns on (3) place the filter (14) in the filter holder (4) (fig. C)and fill it according to how much coffee you wish to make(fig. D): - A spoonful of ground coffee (7g) for one cup of coffee. [. . . ] The steamer system is Clean the steamer; use fresh blocked; or the milk isn't milk; use cold milk; refill the fresh; or the milk isn't cold; or water tank. The ground coffee is not firmly compacted; or the amount of coffee is not sufficient. Too much water left in the filter holder after the coffee is ready. At the end of its working life, the product must not be disposed of as urban waste. [. . . ]